20 Most Recent
Sanyo DP32746 32 in. LCD Television - Page 8 Questions & Answers
How to reset closed captioning on a sanyo flat
U have CC button on ur remote?Push that button on like CC1,2,3 one of these will get u captioning,but the show must have captionning in it programming it have CC and a square before show started it indicated it have captioning.
Sanyo LCD TV screen is blank but sound is working.
The reason there is no picture is (95%, certainty) the loss of the high voltage. The high voltage is what produces the energy for the raster lines upon which the video is modulated.
Therefore, the video and deflection circuits may be working just fine but you cannot see because there is no high voltage to the picture tube.
Now, it is possible, also that power to the picture tube filaments has been lost, or that the power supply to the biasing voltages is defective or that the picture tube sockets are corroded, but the overwhelming cause among TV sets is loss of high voltage.
Refurbishing the high voltage will probably cost $250 or from anywhere you go. Even if you do it yourself and buy the parts wholesale you will not save a tremendous amount. So, unless you are very handy and know how to troubleshoot, solder, repair and test, I think you are better off finding a good shop for the repair.
Good luck!
I have a 46 inch sanyo lcd 1080p that is only 2
I'm having the same problem with the same TV. I called around to repair shops and I guess it's fixable. Haven't taken it in yet but I was told it most likely is a bad module. But this seems to be a really common problem with this television
Sanyo 32 in flatpanel, Is there a setting to
No thats a pain huh? It is not actually louder ..oh I know it seems louder but technically it isn't, You see what they actually do, is they compress the audio, into a special mid sound range, that to most people sounds LOUDER, and so you "Pay Attention" Thats why the automatic limiter, that IS built in won't work, diabolical huh?
I just bought a used Sanyo 32
if you are using a cable box, run a.v.cables, hdmi, or s.video to your set. i'm taking for granted that you ARE auto programing your set thru the menu and you do have the setup/menu selection on all channel search. if you've hit the reset button on the remote...you'll need to unplug the power to the tv. if it is a problem with the connection, i have had problems like this repaired by pros for about $50.
Tv problem
where is the reset button on Sanyo DP32647
3 YEAR OLD SANYO DP 32746. SHUT ITSELF OFF, CAN NOT TURN BACK ON
If you leave the tv unplugged for 2 days (atleast) then plug it back in and try to turn it on and if it comes on its the power supply board. If it comes back on it will probably shut off between 30min to 4hrs and you would have to unplug it for 2 days again. All the power needs to drain out of the tv. If thats the case take the back pannel off and check the part number out on the internet. Not hard to do becarefull touching things the power supply does store a little bit or shock in it. Good Luck.
Not finding what you are looking for?