20 Most Recent Homelite Used Super Ez Chainsaw Manual Oil Line 65214 - Page 7 Questions & Answers

Fully close the choke, shut off switch is toggled to "run". Pull start without using the throttle until the engine fires. Set the choke to the second position, pull start again until the engine fires and idles. Allow some time for the engine to warm up while giving light throttle and when the engine responds smoothly, set choke to fully open.

50 to 1

read your owners manual.

Try Parts Tree.com

Sounds like the carburetor is defective, try rebuilding it.

refer to owners manual, look at existing spark plug, or type in search engine Homelite 26 B leaf blower spark plug

check stop switch wire and switch

40:1 mix

Homelite saws have a gap setting from .010 inches to .020 inches

Been answered.

Follow the link How to Adjust the Carburetor on Homelite Weed Trimmer Hunker

You throw it in the trash and buy a real chain saw

First unplug your spark plug. Take off the engine shroud (cover) and expose the flywheel. Loosen your coil. Put a paper business card (roughly .10" "- .11") between the two legs of the coil and the magnetic spot on the flywheel. Let the magnet on the flywheel pull the coil to itself WITH the business card between. Make sure you get the card between both legs of the coil. Snug 'er down and rotate the flywheel to release the card. That's your clearance.

.020"-.025"

UT33600 UT33650 26cc String Trimmer

I imagine that it supposed to pull fuel from the tank or it will not run

Sounds like an engine running very lean. Check fuel supply. Make sure you have clean fresh fuel and a new fuel filter. If the carb sits on top of the fuel tank and "drinks" through a pick up tube, it may have an air leak in it. (Think cracked straw sipping a soda). Also be sure the bolts connecting the carb to the engine are snug. Leaaks around those gaskets will cause the same trouble.