20 Most Recent Homelite Used Super Ez Chainsaw Manual Oil Line 65214 - Page 4 Questions & Answers

yes it can be replaced. any lawn mower parts store will have this bulb. there are two screws that hold it on. take it with you to get a new one

hi what model machine do you have? ryobi / homelite and jcb use several different carbs one of which i had to get developed heres a link to the carb kit i have the first link is to the carb kit the second and third links are to the carb it fits https://www.ebay.co.uk/itm/223393359179 https://www.ebay.co.uk/itm/222997961157 https://www.ebay.co.uk/itm/221890374453

hi stephen there is no parts number for the primer bulb here is a link to your primer bulb i shall also send you a link to the carb kit for your carb as well i am the only person in the world that sells the original carb kit i had it developed for me when i worked for technotronic industries there is one cheaper one out there but it is to fit a zama carb and not a ruixing carb here is the link to the primer bulb https://www.ebay.co.uk/itm/323510647106 here is the link to the carb kit https://www.ebay.co.uk/itm/223393359179

would take the spark plug out put some BBlaster or marvel mystery oil or some other very light oil in the cylinder. next day see if it loosened up

The following kit includes a pull wire which makes it soooo much easier. This may not be the right kit for your homelite. Just included as an example. https://www.homedepot.com/p/Universal-Fuel-Line-Kit-AC04124/203791910?cm_mmc=Shopping%7CG%7CBase%7CD28I%7C28-32_PORTABLE%7CNA%7CLIA%7CFixed%7c71700000041074954%7c58700004788398043%7c92700040946149284&gclid=EAIaIQobChMI8vqLhZDw4AIVUR-tBh1OAQoqEAQYBCABEgI7zPD_BwE&gclsrc=aw.d Can't remember which line goes to which carburetor port? To get the right fuel line to the proper carb port, connect only the fuel line with the filter to either carb port. Put enough fuel (mix) in tank to more than cover the filter. Press primer bulb several times. If you have it connected to right port, fuel will draw up into primer bulb and expel out the other unconnected carb fuel port. Otherwise switch filtered line to other port and prime again. If still not drawing fuel, then fuel line or primer bulb is cracked or carb repair/replace.

First remove all lines from tank clean tank by spraying carb cleaner into it shake well make sure all gunk is out then blow out with compressed air. Install lines with no 5 going to fitting just below primer bulb the other line no. 3 has connector no 6 and filter no. 4 on it.

Line up.

Try starting as you would normally and check plug for gas on plug tip if none probably carburetor if fuel on plug then Remove plug attach body of plug to aluminum housing and pull watch for spark at plug gap. If none either stop switch Wire grounded or coil bad.

Not entirely sure of question ?

Model number needed.

No. 19 is oil pump.

Need model no.

Check with Parts Tree Repair Clinic they will help.

Could be pressure setting but probably worn O rings and gaskets in pump.

Rebuild pump.

Heck switch by removing wire to coil. If no help remove spark plug laying metal part of plug agains cylinder head, pull cord and watch for spark. If you have none look for grounding if wire to coil along with grounding of spark plug wire. If you find no problem replace coil making sure you check gap of old coil and match with new.

30:1

Need it number