Top 20 Homelite Ignition Chip Replaces Points Condenser Xl12 - Page 2 Questions & Answers

0,3 - 0,4 mm

0.012 - 0.016 in.

Unlikely as it has a 4 stroke engine. Unless you didn't bother to check the engine sump oil. Basic maintenance here. Try and turn the crankshaft output with a wrench. https://www.google.com/search?q=Homelite+pressure+washer ..

Read the 2stroke oil can

You don't need to own a mint plantation or freeze your mint. You can have it at home and without much effort. How? With AeroGarden pods for veggies, herbs, flowers and plant-based foods. AeroGarden

A 50-1 ratio is the answer.

The spark arrestor screen sits inside the muffler on a gas-powered leaf blower. These screens help prevent heated gases from escaping the internal combustion engines. https://www.ehow.com/info_8446641_important-arrestor-screen-leaf-blower.html

check filter or carb needs cleaning -rebuild or replacement

Homelite seems to think it is 5,000 watts https://manuals.homelite.com/documents/2024 ..

Chainsaw oil pumps are fairly simple affairs, to increase oil flow you obviously cannot increase the engine speed, so you increase the throw of the pump shaft, so the pump shaft not only rotates, it moves back and forth ( the throw ) so the back of the pump shaft is cut off at an angle, the adjuster screw sits on the back of the shaft, so now when it rotates it moves in and out due to this angle, so the close the screw is to the centre of the shaft the lesser the throw, the further out the bigger the throw, so unscrewing the adjuster ( anti clockwise ) increases the flow, and visa versa.

Here is a link to a search showing the manual as a pdf. https://www.google.com/search?sxsrf=ACYBGNTfb-N20gTi_jyY8AhRQsrREyx1gQ:1569087551920&q=homelite+bx90+bandit+blower+manual&spell=1&sa=X&ved=0ahUKEwirhJ3RuuLkAhUBXq0KHR1uCvMQBQgvKAA&biw=1242&bih=598

Check the fuel lines, it has small leaks

Go right to the source - Homelite: http://manuals.homelite.com/

Try cleaning the carburetor and blow or clean jets. Then new mix and clean fuel. Start up, and probably set the idling to a little faster to start then adjust for good idle speed so it won't stall. Hope this may help.

The oil ratio is not adjusted to the engine it is the formulation of the oil. You mix your oil the way the bottle states. I have been working on 2 cycle engines since the 70's at a motorcycle, ATV and lawn & garden dealership. If you have doubts about a 50:1 oil do like I do and put 8/10ths of a gallon of gas in you jug and use a bottle of oil for a gallon and mix.

Defective carburetor.

sounds like the needle and seat need to be replaced. the carburetor is flooding out and running in the oil. after you replace the needle and seat i would recommend changing the oil.

you should be able to replace the bulb. take the model numbers to any mower parts store and they can get you this part.

As with any brushed electric motor both brushes should be changed, it is not good practice to have different lengths of brushes.

Always use unleaded gasoline with a pump octane rating of 86 or higher. Never use old, stale, or contaminated gasoline, and do not use an oil/gas mixture. Do not allow dirt or water into the fuel tank.

16 to 1 There is a universal synthetic oil that works well for most all 2 cycle engines and causes less problems than standard 2 cycle oil. Also try rec 90 or rec 89 gasoline it contains no alcohol and will stay stable longer.