20 Most Recent Zebra Z6M Plus Thermal Label Printer - Page 9 Questions & Answers

The "ribon in" warning is because you set the printer to print DIRECT THERMAL insted THERMAL TRANSFER. The first mode is for printing directly on the thermal labels, not for using a ribon. The ribon sensor detects that a ribon is pressent and you get this message. You need to change the printing mode to Thermal Transfer from the printer Setup Menu, or from the Print Driver instaled on PC.

First I'm asking you, what model of printer do you have? Check if the printhead installed is a 300dpi one. Also check if the model of printer is 300dpi configuration by verifying the "printer part number/serial number" label. If the printer is a 300dpi model and the printhead was changed with a 200dpi, all the label content will be printed bigger, just like you described.

Don't do it!! See Zynga security

You can find zebra/eltron 2844 ctp driver here on this link driverupdate us .Take a look and enjoy

reduce the heat, dowgrade the darkness

yep, you can do it, but needs new prinhear and change gears inside, or thought settings you can change as well.

inside of printer there is a flag, its possible its out the sensor even when printhead its down.

what model? test diferent ribbon.

turn off printer and press "pause" button + "power on" at same time, keep pressing "pause" button for 5 secs. it will star printing a 'pouse test" ike a barrcode. After 3-4 labels, just paused the job otherwise it will never stop printing untill u swicth off again. if printing halp printer, tried to reser printer to factory default and try again. if still printing half, the printhard its faulty.

try with wwwseagullscientific.com drivers, this driver have the option to resset printer to factory default.

try to reset printer to factory default. dowload the seagullscientific drivers and reset from there, much easier. hope it helps, Paulo.