20 Most Recent
Amana NDG2330AW Gas Dryer - Page 7 Questions & Answers
Model #NGD7200TW starts up again after drying cycle stops
TO CHECK ON YOUR PROBLEM YOU CALL AMANA OR WHO THE NAME BRAND .< 1 > GIVE THEN THE MODLE NUMBER / SREAL NUMBER .< 2 >GIVE THEM THE CODE THAT YOU SEE "4" . LOOK VERY CLOSLY AT YOUR DISPLAY AND SEE IF THERE IS A LETTER YOU CAN MAKE OOUT. THIS INFO WILL HELP GREATLY.
12/11/2015 6:59:25 AM •
Amana Dryers
•
Answered
on Dec 11, 2015
I have a amana dryer and it want turn on was the problem
I really need to no
Check the fuse in the main box in case a circuit breaker has tripped
If that is fine check the fuse in the power plug .
If that is fine too and power is getting to the machine it may be a switch problem , you can test this with a multimeter observig safety precautions.
Beyond that you will probably need a repairman/technician to diagnose it
6/26/2015 11:26:08 PM •
Amana Dryers
•
Answered
on Jun 26, 2015
Where is the heating element located
Bradley,
Just saw your other question. The heating element is located below and behind the drum. You will have to remove the front panel and the drum to gain access to the heating element. Be sure to unplug your dryer before attempting any repairs. Also, since you will be removing the drum, make sure that you take note of how the belt goes around the motor and idler pulley. You should also take a good look at your belt, might be a good time to replace it while you are in that deep. If it has tiny cracks on the inside, I would recommend replacing it. Hope this helps!
5/30/2015 4:16:59 PM •
Amana Dryers
•
Answered
on May 30, 2015
On the amana LEA30aw which wires go where on the heating element?
There is usually a schematic pasted to the inside service area unless it fell out. Read it & start tracing wires. The power to the element should pass through a fuse, a thermistor(cycles power on and off relative to heat and a safety switch that kills power if it gets too hot. Don't take short cuts.
5/14/2015 8:24:53 PM •
Amana Dryers
•
Answered
on May 14, 2015
I want to down load a manual
David,
Can you give us some more info on your dryer? If we had the model number, we could possibly give you a link directly to what you are looking for, if it is still available. Without that number the best we could do is point you to the manufacturer's website to find a manual.
5/10/2015 2:43:47 AM •
Amana Dryers
•
Answered
on May 10, 2015
Not finding what you are looking for?