20 Most Recent
Janome Harmony 2039 Mechanical Sewing Machine - Page 2 Questions & Answers
I need to know
Ask your local Janome Dealer.....take the old one out as a sample, it is a bayonet fitting .....undoes anticlockwise
New Home sewing machine instruction manual 2039 (Jenome)
I will quit being lazy and find my manuel today...... i thought I could save time and look online. No such luck. If you have an email address I will send of fax or mail to you. I feel bad for everyone looking for it. So I will check in a few days to see if you still need it.
Lisa
What is pressure foot on
This is the foot that comes down and holds the fabric layers under the needle.
There will be a pressure foot lever to raise and lower the pressure foot at the back of the sewing area, it usually operates vertically, although some makes have a lever that works horizontally.
The pressure foot needs to be lowered BEFORE you start stitching as it activates the top tension and also helps with the stitch formation by holding the fabric firmly as the needle moves up and down.
You can read some general sewing machine info at
www.sewing.about.com too.
When I sew a seam, the bobbin stitch will just
It has not been under tension when the seam was sewn, check your bobbin threading sequence and refer to your manual. The thread needs to click into a tension spring or similar device on all sewing machines.
For general machine tips, maintenance and help, try
www.sewing.about.com - it has lots of information.
How do I get thread from bobbin to come up?
You have to thread up the machine before that can happen...
Wind the bobbin first
Then thread the machine properly
After that put the bobbin in the bobbin holder
And place it in the shuttle make sure the notch on the bobbin holder is the right way...
Then all u do is wind the wheel on the side of the machine towards yourself and it should come up, quite magical I suppose...
Middle fabric guide missing, where
Just call Janome at 1-800-631-0183 and order through them, at least you know that it will be the right part. Good luck and happy sewing.
How do you drop the feed dogs?
in the compartment where the bobbin goes there is a metal "L" shaped clip to the right of the bobin. you need to push it down and to the left or right (can't remember which off hand)
Tension dial on my sewing machine is not working
Hi, Liz. When you adjust your tension, be sure the pressure foot is down. The pressure foot needs to be up when you thread the machine so the thread will slip easily between the tension disks, but when you adjust the tension the disks have to be tight (pressure foot down).
There are other possibilities, but this is the best place to start running the problem down. Please let me know if this does the trick, ok, and if not, we can try something ele.
Happy Sewing
Robbie
Not finding what you are looking for?