20 Most Recent Briggs & Stratton Gas Pressure Washer 20244 - Page 6 Questions & Answers

https://www.jackssmallengines.com/Products/BRIGGS-STRATTON/Spark-Plug Check out this chart.

Check out this torque site. https://www.doityourself.com/forum/outdoor-gasoline-electric-powered-equipment-small-engines/457808-ok-increase-rpms-briggs-stratton-mower.html

Need the full serial number off engine

Would recommend you go online and find and buy this manual, B$S are like all mfg. lately and are not sharing.

Check and find a store that sells Briggs parts and ask them or type it in google and see where you can order the parts from. There might be a manual at this web site. I FOUNd THIS WEB SITE that I think will help you with this question and a lot more. Since this web site will have access to many different vehicles I hope you do not feel like I am lazy by just passing along the web site instead of giving you the exact information you asked for. Go to this site to find a manual to help you. https://www.browsemanuals.co/lander_zrk65_test14.html?t1=1535071160&t2=65192170713&t3=kwd-28425796&gclid=EAIaIQobChMI-oybpN624AIVwdVkCh2GtguWEAEYASAAEgJ9yvD_BwE

No wires are needed to engine to make it run if magneto ignition. Now to stop you will need one wire to a ground in switch. Electric starter require 2 wires directly from battery with a solenoid on the positive wire and one low amp actuator wire to it from ignition and must be grounded common with engine is best.

there's a dot on each of the gears. match them up

30 ac

Sears PartsDirect.com will help you

.030

If it is like a car you need a code reader

Try Parts Tree repair clinic they may have a video the wire off of the coil goes to the brake the other two go to the altinator.

Press on the trigger on the wand to release pressure . then pull on the cord and it should work.

Check on line with Parts Tree repair Clinic they may have a video