1998 Isuzu Trooper "1990 codes" Questions

...hand shake code on most troopers. will be repeated three times. then each code will repeat its self three times. when all codes are flashed it will return to the 12 code. reference 1990 Isuzu ...

...codes from check engine light The 1990 Isuzu Trooper with a 2.8L GM engine, the diagnostic connector is located directly beneath the coin try in the front of your center console!! Along with the ...

1990 TBI Gas, Manual Transmission. The Check engine goes on after a few miniutes at idle speed. When the car is driven, the light turns off almost inmediately, The same thing happens when driving down

Am replacing radio in 1990 Holden/Isuzu Jackaroo. Current loom has following coding - red & red/white; blue & blue/white or blue/pale blue; red/grey; green/blue & white; brown & ...

p1626 4jx1 engine will turn over but not fire. Have just replaced oil rail pressure sensor, car started and ran well, travelled approx 10 k's and parked for about 20 minutes. Car now will turn over ...

...codes in 1990 matter, its got so few, and all are catastrophic failures, and MATTER. if you pull sensors ALL ECU go nuts (02 is ok to pull) 1990 , 10x more nuts. in 1996 (usa) less nuts, but still a ...

Warning lights on dash come on after runing it a short period on When I start the trroper in the morning it runs fine, If I don,t let it run more that 15 minutes the warning lights on the dash come on

1991 trooper transmission light flashes and at same time trans performance is poor? I think my boyfriend have been putting ATF not Dexron II in it. If ATF has been used will this cause poor ...

Check engine light on; used obd to read code. It said O2 sensors were bad, I replaced both O2 sensors. 6 miles later the check engine light came back on. I read codes again and this time it said "

Tranny wont shift out of first gear It will shift through all gears then a few seconds it will quickly downshift to 1st.... then it goes really high in rpms and the check trans light comes on. I have ...