...ball joints for excessive play. Jack up the front on either side and have a helper push and pull on the top or bottom of the tire. Watch the area where the hub pivots on the axle. if both sides check ...
...bottom of the reservoir tank. This line goes to the front fluid cooler under the drivers' side front bumper. The line has both metal and rubber on it and the line mounts to the frame with plastic ...
...A frontend alignment can help some steering problems. Some of the Idler arms and Pitman arms can be replaced without a frontend alignment, but it is recommended. Also the parts may need specific ...
Question about Ford F-250
...bottom part of ball joint is in the arm and the other ball part is still connected behind the rotor. Hi Adeline,The lower ball joint is an integral part of the lower control arm. If the ball joint is ...
replace a lower ball joint on 2004 mercury mountaineer? Remove the brake caliper by removing the two bolts that connect it to the steering knuckle. Remove the lower ball joint cotter pin and retaining
Question about Ford F-250
...replace it wit the new one lining up the backside of the compression nut with the mark you made with the marker then tighten. then put the bolt on the bottom of the ball joint assembly back in to the ...
...replace ball joints on 1997 dodge ram 1500 jack up truck support truck remove brake caliper and support the caliper dont let it hang by the hose remove cotter pin from bottom of ball joint remove ...
...bottom ball joint. What tools do you need in replacing the upper ball joint. Thanks If you are replacing with new....you have to grind off the old if it is rivited in...to install...it's new hardware ...
bottom of the ball jointCarefully align all pieces. Then press the ball joint into the lower control arm until it is completely seated against surface of lower control arm. The ball joint is correctly
...replace these on the side they were removed from for the alignment. 5 Lift the upper control arm off and remove the upper ball joint using the ball joint installer kit. This procedure is only ...
580 questions posted
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions