1999 Ford F350 Regular Cab "minimum thickness wheel rotors" Questions

Ad

...minimum thickness standards for safety) or you can replace the warped rotors with new ones. In both cases, I would recommend also replacing the brake pads too. Hope this helps. brakes yes rotors ...

Ad

...minimum thickness of 0.794mm (1/32 inch) above the front disc brake rotor shield. CAUTION: Always replace all brake shoes and linings on an axle. Never replace only one wheel (1007). Removal To avoid ...

Ad

minimum thickness for buick lesabre front rotors minimum thickness of front rotors Hello there From a kind chap on this page http://buickforums.com/forums/threads/18395-Service-limits-for-brake-rotors

...and not warp(pedal or steering wheel shakes when braking), Reuse them. Using this theory you can get up to 3 sets of pads off the rotors. The minimum thickness is stamped on the edge of the

Question about Ford F-350

1 Answer

...minimum thickness I don't know the min thickness, but I have an outback just like yours and if there is a problem with uneven rotors it's usually cheaper and easier to buy aftermarket at NAPA auto or ...

minimum thickness shown on the rotor, it should be replaced. The finished braking surfaces of the rotor must be parallel within 0.007 in. (0.178mm) and lateral run-out must not be more than 0.003 in.

...minimum thickness have rotors machined or buy new ones reassemble do not damage caliper piston boot do not disconnect brake line loosely install brake reservoir cap have proper brake fluid handy if ...

...minimum thickness that it can be lathed to. (Cut to) Brake rotors resemble a flat disc, and there is a minimum thickness that they can safely be cut, (Lathed), down to. Brake Drums resemble a round ...

...minimum thickness, warping is more likely. If you replace the rotors, replace the pads at the same time. The pads that are on the car now are wearing unevenly due to the warped rotors and can cause ...

...Replace the front rotors. Refacing does not work on Sequoias. The metal removed to get the rotor "true" is usually below minimum safe thickness, and the vibration comes right back when it gets

Not finding what you are looking for?
1999 Ford F350 Regular Cab Logo

389 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...