2004 Chevrolet Suburban "removing installing oil pan" Questions

oil pan on my 2004 chevy suburban 2 wheel drive. It is a hairline crack. Do I have to remove the entire engine to install a new oil pan? Can the frame cross member be removed to allow room to swap? Is

oil. You will have to pull the engine unless you can remove the pan and have room to work. It is a real time and work saver if you can do it without removing the engine, the crank only needs to drop a

...oil pump is the unit the pick up tube and screen are attached and it comes down by removing two bolts.The pick up tube is the hard part. Last I kmew they are pressed in and hard to separate from the ...

pan for fluid to drain into,there will be a set of gear's through the gear's on the right side of the ring gear there will be a pin about 13/4" in dim. and about 5" long at one of the end's there will

...removing the drain the pan. Myintention is to install it behind a 305 in a 1986 Suburban 1/2 ton 2WD.The one that came out of it is fried. I found this one on craigslist,from a camaro man who I ...

oil pan on a 2004 chevy silvarado 4.8 liter need step by step instructions 1. Disconnect the battery negative cable. Refer to Battery Cable Replacement (Positive/Negative) in Starting and Charging. 2.

oil pan. Remove the oil pan drain plug. Remove the oil pan bolts. Remove the oil pan. Remove the gasket. Remove the magnet. Remove the oil filter. Remove the filter neck seal. The transmission oil pan

...oil pan bolts from front and sides only. 4. Loosen the rear oil pan bolts approximately four turns. 5. Lightly tap the oil pan with a rubber mallet or pry to drain the fluid from main case. 6. Remove ...

...oil pan and it will cost 1800 to fix. can i buy another oil pan and put it on myself? OIL PAN REMOVAL Drain engine oil. Remove front engine mount bracket. Remove power-train bending strut. Remove ...

oil pan to put new gasket Removal Procedure 1. Disconnect the negative battery cable. 2. Drain the engine oil from the engine crankcase. 3. Remove the exhaust flex pipe retaining nuts from the exhaust