2008 Volvo S40 "remove accelerator pedal" Questions

Remove accelerator pedal 3. Fold carpet back. Remove 3 retaining screws, and fold up cover 4. Remove filter by pulling it out behind the brake pedal NOTE: The direction of air flow is indicated on the

accessable only from driver's side after accelerator pedal assembly is removed. There are three screws that secure the housing. The carpet will also need to be pulled back slighty to remove the filter

...remove the accelerator/gas pedal. To do this remove the 3 x 10mm bolts underneath and the 2 on top. When there unbolted remove the gas pedal. Drag the carpet back that's directly under the steering ...

...remove my foot from the gas pedal,it feels like i have applied the brake pedal and stops.The engine is still running and if i apply my foot to the accelerator,it will go until i take my foot off and ...

accelerator pedal position sensor circuit I have 2008 Volvo S40 2,5 5T. Because of the broken timing belt the head was replaced.When I start the car in the dash show SRS air bag need service urgent.i ...

...Disconnect the accelerator pedal position (APP) sensor electrical connector. Reposition the carpet to access the lower nut. Remove the accelerator pedal nuts. Remove the accelerator pedal

remove foot from brake pedal to accelerator pedal Step 4 apply presure to accelerator pedal untill desired speed has been acheived Note these steps will not work for manual transmission see section 37

...remove the steering column if you have not already. Lift the accelerator pedal and slide the heater core past it. Depress the brake pedal and remove the heater core from the heater/air conditioning ...

...ACCELERATOR PEDAL IT HAS BOLTS HOLDING IT IN PLACE.JUST UNPLUG ACCELERATOR CONNECTOR AND REMOVE THE BOLTS THEN SENSOR. I was wondering how do I put my accelerator sensor on a 2004 Pontiac Grand Prix ...

...remove the pedal and sensor assembly. Installation is the reverse of removal. Fig. APP sensor mounting TestingInstall a 3 amp fused jumper wire between the 5-volt reference terminal of the APP sensor ...