...canon mp 950 has a error code 6A00 There is a problem with the carriage lift mechanism. Probale causes 1.PR Lift shaft assembly 2.Sheet Feed Unit 3.Logic Board Only your local Canon Dealer will ...
error 5100 MY PRINTER SHOW THE ERROR CODE 5100, WHEN I OPEN MY LCD SCREEN OF PRINTER (CANON PIXMA MP-476)..???? - Carriage unit - Timing **** strip film - Logic board ***'y - Carriage motor problem
...logic board error code. The PCI Bus error is detected by the ASCI. Sounds like it needs new logic board. but i suggest you to first of all you can try to reset your printer - 1. Turn the printer off ...
Question about Canon PIXMA Office Equipment & Supplies
...head and error 5200. The error 5200 is either print head overheated or the logic board is faulty. If it overheated, there might be burn marks on it somewhere or some distortion due to excessive
Question about Canon PIXMA Office Equipment & Supplies
...power cord. If you have changed the internal power supply (the black box in the left real corner), then all that is left is the main logic board. That repair would be cost-prohibitive on this
...or a main logic board fault. Due to the cost of the machine and the cost of the repair, it just does not make is cost effective and really as replacement machine is by far the better option.
Question about Canon PIXMA Office Equipment & Supplies
case middle cover, unplug all cables from the logic board, lift the print engine up and out and replace the pads. After that you need the service mode to reset the counter if it runs after re assembly
...logic board or the purge unit. I hope this helps you to understand what the printer needs. Good Luck with it. My canon PISMA MP810 has been a marvel until now. When I try to print from my computer, ...
...the LF drive. Please remove any foreign materials if encounter. 3. Check cable connection. 4. Replace LF encoder or Logic Board. Thanks for using fixya... And please don't forget to rate
...just come on and you don't hear anything moving inside and no error codes, the main logic board could be bad. A rather expensive repair. Have you tried unplugging the printer and plugging in
2,715 questions posted
Usually answered in minutes!
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions
1,216 Questions