...idle speed it is on idle at 1100 rpm when at operating temp@ To adjust the idle speed on a 2010 Honda Fury, you'll typically need to locate the idle adjustment screw. Here's a general guide: Locate ...
Question about Motorcycles
the idle mixture screws first and then adjust the idle speed screw to compensate adjusting the idle mixture screws will alter the idle speed but when properly adjusted then adjust the idle speed screw
...idle speed a bit. Look at the top of the carb and you'll see a large round looking cover. On the right side of this cover, there is a small screw. This is the idle stop screw and it sets the idle ...
...idle speed, using the tachometer needle, while the engine is running. Ideally, the engine should idle steadily at 1,250 rpm. 4 Adjust the engine idle speed to 1,250 rpm, using the idle adjuster screw ...
Question about Aprilia Motorcycles
...idle speed, using the tachometer needle, while the engine is running. Ideally, the engine should idle steadily at 1,250 rpm. 4 Adjust the engine idle speed to 1,250 rpm, using the idle adjuster screw ...
...idle speed screw, which sits higher on the slide housing than the idle mix screw, for proper idle speed. If no idle speed screw exists, turn the throttle cable adjustment on top of the slide cover ...
Question about Keeway JL 12511 Motorcycles
idle speed set too low? If so, adjust it, using the idle speed adjusting screw, to the correct idle speed (900 RPM). If that's not the problem, then check for air leaks between the carburetors and the
5 questions posted
Usually answered in minutes!
2 Questions
1 Questions
2 Questions
