2008 Saturn VUE "remove rear wiper blade cover" Questions

...remove the rear wiper cover on a 2008 saturn vue 2008 Saturn Vue rear wiper blade: Pop off the cover over the bolt that comes out of the rear window. Unscrew the nut. Now you can remove the assembly. ...

...rear window. Unscrew the nut. Now you can remove the assembly. Give the old wiper a tug and pull it out. Snap in a new 11-inch wiper (you can get a nice one for about $7). Replace the assembly, bolt ...

...rear wiper replacement changing rear wiper blade I just replaced mine. Lift the rear wiper up as far as it will go. which is not very far. Place your fingers on each end of the wiper and pull down. ...

...in an "up" position so I can't open my tailgate window. What is the cause for this frozen motor. remove a rear door cover, and turn on rear wiper and listen for motor noise, also check ...

...remove all the interior trim from the rear hatch first. Get a trim clip removal tool at a parts store...it will work much better than just a flat blade screwdriver. You'll have to remove the trim ...

...remove the rear wiper assembly from the rear wiper motor I'm trying to remove the complete wiper arm not just the blade so that I can change the wiper motor. flip the nut cover back up the arm and ...

...rear door.remove 2 plastic push tabs with removal tool.pry plastic cover off carefully removing push tabs with removal tool or flat blade screwdriver about 10 of them if I remember correctly pull ...

...remove the pannel cover on the rear hatch door I can get to the rear wipper motor Exploded view of the Explorer/Mountaineer rear liftgate trim panel (click for zoom) Rear Window Wiper Motor Fig. : ...

...rear wiper arm is attached with a single nut in the center, 1.) pry the cap off that is covering the nut. It pivots toward the blade. 2.) Remove the nut holding the blade assembly. 3.) lift the arm ...

...rear wiper blade 2006 nissan murano You need to first remove the plastic cover (it just snaps on at the base & lifts upward) that hides the 10mm nut. Remove the nut & wiggle the arm a bit to ...