How to replace the gasket for the intake
SOURCE: 93 Dyna low rider fork oil.
your local hd shop should be able to answer this for you as its a mesured amount and to much or too little will make the bike not handle right
SOURCE: replace intake manifold gasket 2008
Buy you a standard L-shaped allen wrench, put the short leg in a vise and bend it a little bit more in. Cut the short leg nearly as short as possible still allowing full engagement into the hex of the bolt.
Some people recommend to get a good seal to loosen the head bolts when tightening the intake bolts to allow the heads to float to the intake. You do not have to.
Just carefully watch the gap between the intake and the heads. Before completely tightening the bolts, install the carb and air cleaner backplate to make sure the intake is squared up and the backplate banjo bolt thread in. Then carefully remove the backplate and carb without moving the intake, and finish tightening the intake bolts. Get the bolts as tight as you can, use anti-sieze. It comes off easy. Be sure to clean everything up nicely. It i not a hard job ...just tedious.
480 views
Usually answered in minutes!
×