Evaporative Emissions (EVAP) Canister Purge Solenoid
In the engine compartment, on the right side of the engine, near the valve cover
Evaporative Emission (EVAP) Canister Vent Solenoid
On the vehicle underbody, above the rear differential
It is located under the car near the gas tank on a tray with the fuel vapor storage cannister
SOURCE: 2004 Pontiac Grand Prix Evaporative Canister
you should be able to fix it look for a can near the fuel tank that has vacuum hoses coming out of it and you should be able to just buy the bad solenoid
SOURCE: HAVE A TROUBLESHOOTING MESSAGE PO446
DTC P0446 Evaporative Emission (EVAP) Vent System Performance
The vehicle control module (VCM) monitors the performance of the evaporative
emission (EVAP) system by applying a predetermined level of vacuum to the
EVAP system and monitors the vacuum decay rate. The VCM sets this diagnostic
trouble code (DTC) if the vacuum decay rate is more than a predetermined
value. The VCM monitors the amount of vacuum and the amount of pressure
in the EVAP system by monitoring the fuel tank pressure sensor. For
this DTC, the VCM turns ON both the EVAP purge valve and the EVAP vent
valve when the Conditions for Running the DTC are met. This applies
an engine vacuum to a closed EVAP system. The VCM turns OFF both the
EVAP purge valve and the EVAP vent valve when the system reaches a correct
amount of vacuum. The EVAP system should quickly RELEASE the vacuum
in the EVAP system with the EVAP purge valve OFF and the EVAP vent valve
OFF (open). This test indicates a blocked or restricted EVAP vent path
if the EVAP system fails to release the vacuum quickly enough.
SOURCE: location of the evaporative cannister solenoid? 2003 saturn vue
Depends if the engine is 3.0 or a 2.2?
3.0 purge is on the top, back side of the intake. Black, cylinder. Looks the same on a 2.2, but is located next to the air filter.
SOURCE: 2006 saturn ion 2.2L engine code came up for EVAP purge/vent
replace your pvc vavle then have your cars underbody washed
SOURCE: 2007 SILVERADO V6 EVAP PURGE SOLENOID
The evap purge solenoid is located on the intake manifold. The evap vent valve is located on the side of the fuel tank. If you have a P0449 or P0452 (I think) DTC, it will be the one on the tank that you need to replace.
6,249 views
Usually answered in minutes!
×