Well im not sure why you are asking this question . They are two differant systems the mas air flow and the idle air intake bolth run off a 5 volt referance voltage but are not related so to speak to each other as far as the same ref voltage the same ground as every thing else .The IAT MAP TP ECT and fuel pressure sensor are one side and the MAF EGR and the EVAP are on the other side but all on a common ground . Ex plain what you are trying to do and why you are trying to do it and mabey i can make your life a little easyer and what caused this problem
ok thanks. I am trying to install a performance chip that is supposed to attach to the MAF sensor using to have the five wires attached to the Of the MAF sensor
The performance Chip has to wires and is supposed to Connected two out of the five wires coming off of the MAF. I don't know which of the two wires to connect with.
I am trying to install a GForce Chip and need to know that same information. Did you ever determine which wires to attach them too?
×
766 views
Usually answered in minutes!
×