My srs light had been on

You will need to take that to a shop that handles airbag/sir, srs systems and can use a scan tool that will read and define the error code that is making the light blink.

You should have it scanned but before that make sure you didn't blow any fuses in fuse panel or box

Sir, I think just the light have problem,. you can have a try of HID light.
http://www.chinasinoy.com/search/?q=hid , this light cannot fuse filament.it is durable.

For SRS light coming up issue problem,check the list of help links provided below.Click the link to go through its procedure :-----How i solved SRS and AIRBAG OFF light problem ? http://technoanswers.blogspot.in/2012/02/how-i-solved-srs-and-airbag-off-light.html----------------

Airbag and srs light off?
http://technoanswers.blogspot.in/2012/02/airbag-and-srs-light-off-on-mercedes-ml.html
---------How to remove SRS airbag? http://technoanswers.blogspot.in/2012/02/how-to-remove-srs-airbag-on-honda.html
---------AND FOR ,

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

srs stand for safety restraint system. the seat belts and air bags. trying to figure out which part is bad is your first step. lots of wires to that system plus the seats and steering wheel. you wont be able to figure that out on your own sorry.

The SRS, or supplemental restraint system, on your Honda Accord 2002,


Read more: How to Reset a Honda Accord SRS Light | eHow.com http://www.ehow.com/how_6403892_reset-honda-accord-srs-light.html#ixzz0tQdveFZn
responsible for deploying the airbag in the event of an accident. If this system is malfunctioning, the airbag may not deploy properly during an accident. However, the system does warn you of a system malfunction. The yellow "SRS" light on the dash will light up, indicating a problem with the system. Once you've fixed the problem, you need to know how to reset the SRS light on your Accord

Read more: How to Reset a Honda Accord SRS Light | eHow.com http://www.ehow.com/how_6403892_reset-honda-accord-srs-light.html#ixzz0tQdgZ0ic

I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

Working on the SRS is very hazardous and therefore is not a DIY repair. Take the car to a professional for diagnosis and repair of the SRS.

It is my understanding that the SRS is a dealer only reset because it requires a code that is proprietory to MB dealers only. Now, a garage with a good scanner (loaded with applicable MB program) may be able to reset it for cheaper than a dealer. Nonetheless, I do not believe you can reset it on your own.

A side note, as long as the SRS light is on, your airbag and/or belt tensioners may not work if you're in a collision.

I watched a video on resetting the airbag indicator for HONDA civic. It seems a simple thing to do. have a look at the video. It may be helpful.

fr.truveo.com/How-to-Reset-SRS-Airbag-Indicator-Light/id/3118442620 - 85k -