How to replace a rear turn light on a 2000 ford expedition?

does it have a trailer connector installed by uhaul or anything if it does possible corrosion in wires or a bad ground at rear of vehicle

brake and turn are the same filament in the bulb. Try a new bulb. if that doesn't work your going to chase a short/ground on that wire back to the switch. get a wiring diagram to help.

I'm not sure what the other person listed but this is what I have. I hope this is the right one for you. If not sorry. Hope this helps and good luck.

2000 Ford Expedition Stereo Wiring Constant 12V+ White/Purple Switched 12V+ Black/Pink Ground Black/Green Illumination Blue/Black Dimmer n/a Amplifier Remote Blue Antenna Right Front Front Speakers 6" x 8" Doors Left Front (+) White/Red Left Front (-) Brown Right Front (+) Green Right Front (-) White/Orange Rear Speakers 6" x 8" Rear Doors Left Rear (+) Light Blue/Black Left Rear (-) Yellow Right Rear (+) Purple/White Right Rear (-) Light Blue

Yes, replace the bulb on the rear.

OK, it sounds like the Ford Expedition from the year 2000 has either a leak in the system (air leak), or the compressor has gone bad causing it to not recover its normal ride height.

The shocks could be blown (air leak in them).

It depends on which component(s) in the system are damaged and need replaced to determine cost.

If you don't hear the compressor running to try to raise the vehicle, the height sensor on the rear axle could be damaged as well.

These are, of course, all of the possibilities that I can think of, off hand, that could be wrong with the system.

This is usually the turn signal lever which also has other controls built into it.

where is the rear door fuse located on a 2000 ford expedition?

just replaced air bag suspension on a 2000 ford expedition, but the check suspension light stil is on how do I disable it.

check pass side rear plug the coolant hose the runs to the heater core can leak coolant into the rear spark plug boot and cause a miss

You have to open your rear door, and on the inside by your lights there are 2 screws that you have to loosen, when you loosen the screws, just pull the light cover off and you will see the bulbs that need to be replaced.