I need help with replacing the driver side window in a 2003 ford f-150,four door super crew cab truck.

There is a lot involved, I would recommend purchasing a chiltons/haynes manual at your local auto parts store for $20. You need to remove the regulator assembly, the trim, the small window frame and the actual window track. A window company takes about an hour to replace it so with no exp, I would expect 2-3....

Removal & Installation
Motor - Front Door

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove the window control switch
3. Remove the front door trim panel and watershield.
4. Tape the window in the full UP position.
5. Disconnect the window motor electrical connector.
   NOTE Support the window motor while removing the window motor retaining screws.
   
6. Remove the window motor bolts and remove the motor.
7. To install, reverse the removal procedure.

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove the window control switch.
3. Remove the rear door trim panel and the rear door trim watershield.
4. Remove the door speakers.
5. Tape the window glass in the full UP position.
6. Disconnect the window regulator electric drive.
7. Position the connector for the window regulator electric drive inside of the door.
8. Remove the bolts.
9. Separate the window regulator electric drive from the rear door window regulator.
10. Remove the window regulator electric drive from the door.
11. To install, reverse the removal procedure.

Motor & Regulator

Fig. Rear Door Trim Panel-Crew Cab

I need help with replacing the driver side window - 506866e.jpgn>Regulator - Power Windows



Fig. Window regulator arm nuts




Fig. Window regulator bolts

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove the window control switch.
3. Remove the door trim panel.
4. Remove the door speaker.
5. Remove the door watershield.
   NOTE Do not remove the window glass from the door.
   
6. Remove the window glass from the window regulator.
7. Tape the window glass in the full UP position.
8. Disconnect the window motor electrical connector (power windows only).
9. Loosen the window regulator arm nuts and pull the arm from the mounting position.
10. Loosen the bolts and remove the window regulator.
11. To install, reverse the removal procedure.

Hope helped with this. Good luck.