Location of starter on a 1985 Cadillac Seville

SOURCE: NEED LOCATION OF THERMOSTAT IN

1. Drain the coolant to a level below the thermostat housing.
2. On some vehicles, access is easier if the front-end beauty panel and the air cleaner are removed.
3. Remove the 2 bolts securing the thermostat housing to the intake manifold.
4. Remove the thermostat housing.
5. Remove the thermostat and O-ring from the housing.

1. Install the thermostat and new O-ring to the housing.
2. Install the thermostat housing to the intake manifold. Tighten the thermostat housing bolts to 18 ft. lbs. (25 Nm).
3. Refill the cooling system using a 50/50 mixture of water and ethylene glycol antifreeze.
4. Install the air cleaner and beauty panel, if removed.
5. Start the engine and check for coolant leaks. Allow the engine to come to normal operating temperature. Recheck for coolant leaks.

Testimonial: "thanks for the great detailed information-greatly appreciated"

SOURCE: where is the starter on a 2000 cadillac seville

under the intake manifold center above the engine block. read my tips section were I explain this location

Colin Stickland

• 22516 Answers
• Posted on Aug 17, 2010

SOURCE: 92 cadillac seville ,starter disabled .how can i

wouldnt be an anti theft device would it ,go to dealer with cars papers and have it reset

SOURCE: 1993 cadillac seville fuse location

trunk

SOURCE: WHERE IS THE STARTER ON

Hello, The starter is under the intake manifold. The intake manifold has to come off. Be careful not to damage the rubber adapter between the intake and the bracket on the engine.