Where is crank sensor on a 2004 hyundai x350 ty

Watch the video of the replacement job 2004 Hyundai Sonata Optima V6 2 7 crankshaft position sensor location and...

P0320 =no signal detected from crankshaft position sensor during cranking, my guess is replace the CPS

other things it could be crank position sensor or maybe a fuel issue?

Crank Position Sensor ? I guess you don't know what that is !

You already answered your own question,when you pulled
on the gas pedal

Hi, in both engines the crank sensor is at the back of the engine by the transmission. The sensor is #10 in the diagram below and looks like the picture included.


4-cylinder crank sensor:


6-cylinder crank sensor:

For Hyundai Car 1999-05 - Intake Air Temperature (IAT) Sensor Location (check several options):

1.- The IAT sensor is located against the firewall to the left side of the engine. It is combined with the Manifold Absolute Pressure (MAP) sensor.

2.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

3.- The IAT sensor is located in the air plenum assembly. On some vehicles it is combined with the MAF sensor.

4.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

5.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.

6.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.


In the next graphic, check the position 2...



FIG : Underhood sensor locations-Elantra 2004-2005 2.0L engine


Hope this help (remember comment and rated this) TY for using Fixya.

U uvicasion del crank shaft position sensor

I found that when my airbag light came on I would reach under the drivers seat and grab the connection and re adjust it and make sure the connection is tight. The light would come on after my wife would get in and move the seat up all the way.
Hope this solves the problem and saves you some money.

Hi

On the 2.7 engine it is located beside the starter. You will have to remove the starters heat shield to gain excess to the crank sensor.

On a 2.7L it is located above and to the right of the starter. You will have remove the starter heat shield to gain access to it.