20 Most Recent 2006 Hyundai Sonata Questions & Answers


hi my name is horatio i have a 2006 hyundia v6 crank but no srart discover that no current is going to the fuel pump how can i find the problem.

2006 Hyundai... | Answered on Mar 16, 2019


If you are new to working on cars, you need to take this to a shop. There is an airbag in your steering wheel and it can injure/ kill you. But I think the clock spring might be going bad inside the steering wheel.

2006 Hyundai... | Answered on Feb 22, 2019


You can find a complete fuse diagram for both fuse boxes on your Sonata at https://automobilediagram.com/hyundai-sonata-2005-2009-fuse-diagram Hope this helps!

2006 Hyundai... | Answered on Feb 21, 2019


The fuse box of the 2006 Hyundai Sonata is under the dashboard, to check the fuse box firstly, you open the dashboard from driver side. For more clarification, I have attached the video which will guide you to the fuse box location in Hyundai Sonata, have a look

2006 Hyundai... | Answered on Feb 21, 2019


check the cluster dimmer switch make sure not turned all the way down to keep instrument cluster lights from glowing brightly.if dimmer switch not turned way down look for blowed instrument cluster fuse.

2006 Hyundai... | Answered on Dec 19, 2018


you need a philips screwdriver and a flashlight, and a telescoping magnet is recommended.

the best way to do this would be to empty your trunk, and lay in the trunk on your back with your legs hanging out and your flashlight pointed up at your work.
inside the trunk directly under the stoplamp you should see a connector, disconnect that and you should see a philips screw. remove the screw.
this part is a little tricky, shine the light up and to the left so that you can see the fastener that holds the bulb into the lamp. take your screwdriver, and place the tip on the flat part that sticks off of the bulb socket and press, so that you can turn it. once the socket is released, remove the bulb socket & bulb with its wire completely.
next, about 2-3 inches to the left of the rectangle where you removed the bulb & socket you should see a hole that is covered with a black foam. remove the foam from the hole, look straight up and you will see another philips screw. remove it, i recommend using a magnet to pull it from its hole after you've loosened it almost all the way, but whatever you do, do NOT do NOT drop that screw. it is almost impossible to retrieve and if you dont, it will rattle.
once you have both screws removed, get out of the trunk and go into the backseat and lift the 3rd brakelamp assembly off of the package tray; it may need a little negotiation, but be patient, it will come out.
once you have the stoplamp assembly out of the car, take the bulb socket, it should have a long flat tip at the bottom. take a pair of dikes and cut that tip completely off. replace the bulb, and install the bulb & socket into the lamp assembly, and re-install the lamp from inside the car, slowly and carefully slding it back into place. (hint, the more of the flat tip that you cut off, the easier it will slide into place).

once the lamp is back in place, hook up the connector, and re-install the screws, and you're done.

2006 Hyundai... | Answered on Nov 28, 2018


there is a tsb for the brake switch in 06 sonatas. it must be adjusted or replaced by dealership. is your check engine light on, if so its probably code p0504

2006 Hyundai... | Answered on Oct 25, 2018



  • 2.4 Engine

ironfist109_287.jpg
  • 3.3 Engine

ironfist109_288.jpg


  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.


Regards, Tony

2006 Hyundai... | Answered on Oct 16, 2018


One word:

Dealer.

Next time just disconnect the battery until you get it towed as this is a warranty item. I'll bet some wondered if this was a prank question like I did, right?

2006 Hyundai... | Answered on Sep 07, 2018


it can be a number of problems one can be you have something is staying on it can be a light in the boot,you alarm is wired wrong or a radio is not off or it can be the battery no good. By jumping the car with a jumper leads can damage the battery, or you alternator is not charging good. First to check your alternator you will need a volt meter and place the negative from your meter to the negative of the batter and the positive to the positive and start your car. If the reading is 14.3 V to 14.8 V your alternator is good than the problem it can be any of the other things that I indicated

2006 Hyundai... | Answered on Aug 25, 2018


Usually it is the regulator in the alternator that causes this condition of erratic charging.

2006 Hyundai... | Answered on May 22, 2018


I had this problem. Through some research and asking some service personnel I found out it is a fairly easy fix. You will need to buy a new relay switch for the door locks. The dealer will/should know what you need. They are located (two of them, buy two and replace both) on the back side of the fuse box. It is not that easy to get back there. I had to lay on my back with my head up under the instrument panel. They are visible and can be removed if you take some time and be careful. Once I knew what I was looking at, it was easy to replace and the remote works like a charm. You can go to an auto supply, like Autozone, and they should have a schematic to show you where these relays are.

2006 Hyundai... | Answered on Apr 18, 2018


There is a chance that you have a bad drive belt inside of the CD player. You probably need to have the unit removed and either sent in for repairs or find someone local to you that is competent in repairing it.

2006 Hyundai... | Answered on Mar 06, 2018


you need to disconnect the sounder. they usually go like this when the internal battery is going, it triggers the alarm to go, so remove it and take it away. ie remove it completely away from the vehicle. and put some were where will not do any harm as the battery can become unstable. its a sealed unit, so you will need to replace it, but in there with the unit you should find another plug, this is for a horn type fitting. use an old horn and that will go off when the alarm goes of but you will not have any beeping or chirping from the horn.

2006 Hyundai... | Answered on Feb 21, 2018


bad switch or plug also check flash relay may have bad connection

2006 Hyundai... | Answered on Jan 31, 2018


You probably cannot fix any of this, but the body shop where you took your car should do so.
I sounds like a wiring harness was involved in the colision.
It may either be severed, or may have been pulled loose by the collision.
That harness mat be under the floor mats, under the car, or somewhere else.
If I were you, I would be sure to find out exactly where this repair was, for future reference.
For example, the body shop may say: "This problem was repaired by repairing the harness by the floor shifter".
God bless your efforts.

2006 Hyundai... | Answered on Jan 30, 2018


Do you have an engine light on? Sounds like the tank isnt venting properly, if you can peak under the car near the gas filler neck, check for a small pipe/hose going to the top of the neck, check for corrosion or anything odd and start with that.

2006 Hyundai... | Answered on Dec 23, 2017

Not finding what you are looking for?

1,949 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Jonah Oneal

Level 3 Expert

14060 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sonata Hyundai

  • Sonata Hyundai

Most Popular Question

cause alternator intermittently

  • Cars & Trucks
Loading...