SOURCE: standard size tires for 2002 jeep liberty limited
should be a sticker with sized right inside the door jam or on door near latch.
SOURCE: Antenna bolt broke, how to fix antenna base.
This is probably way more information than you need, but here goes. I
just had the same problem with my dads 2001 YUKON and wanted to put the
stock wire back. It was not easy, but it can be done.
Remove the glove box, and plastic side panel on the dash
As you are looking through the removed area, there is a silver computer there, remove the bracket and move this computer.
Behind the computer there will be the plug in for the antenna. One side goes to the radio, the other to the fender.
Unplug
the cable, and tape/fasten a length of wire to it so that when you pull
it out, you have a guide to get the new wire back through the firewall.
Remove
the old ant. and then take the guide wire and fasten to the new cable.
Pull this guide wire through while someone else is feeding from the
fender area.
Replug it, and reinstall the computer and glove box door.
Also,
be aware and make sure that the new cable with stud matches the ant.
mast. GM changed the size of the stud (for unknown reasons)and you may
need to get a new matching mast. I could not use my old one
Good luck!
Testimonial: "Thanks Molson! This is exactly what I was looking for before I started taking things apart. I guess I'll leave it for the weekend!"
SOURCE: How to replace the whip antenna on a 02 Jeep
The antenna part unscrews from the fender mount and can be replaced easily. The mount and wire needs to be fed through the fender and firewall, most times making it necessary to remove or partially remove the inner fender liner for access. Not difficult but a pain in the **** to do.
SOURCE: why my 2011 jeep liberty have troubles on idle?
idle controller will need cleaning, you will need to remove it and clean it out it sits on the intake under the intake pipe has some wire going into it, remove the unit and clean out with some carb cleaner spray it in side and cover the opening with your hand and shake it around so the cleaner gets every were do this a few times and then tip out the gunk before refitting also clean the inside top of the intake using carb cleaner and a cloth. when dry spray some wd40 in the idle controller drip it out and re fit the unit. should be fine after this cleaning is done.
105 views
Usually answered in minutes!
×