I think you are right...both are 4.3...should be good to go.
Bell housing bolt pattern is the same between the 2 and will bolt up. Same goes with the small block 350. Same bolt pattern. Your only situation would be in driveshaft length and 4 wheel drive. Measure up the trans from bell housing to back of trans for tranny length. If same, go for it.
SOURCE: engine computer
Built in the firewall. You will see the pin connector connected to it. It is on drivers side.
SOURCE: i have a2001 chevy silverado 1500 heater was not
I would replace the blower resistor first. its down by the blower motor.
58 views
Usually answered in minutes!
×