20 Most Recent
2003 Toyota Celica Questions & Answers
Toyota dashboard CD player won't eject
I had this say problem with my 2000 solara. Here is the fix, remove one of the car battery terminals for a couple of mins (3-4mins). The reattach the battery terminal back. This would make your cd player and car clock reset. once you start your car you should be able to eject the cds. You'll just need to reprogram all your preset radio station. Hope it helps
I have a '03 Toyota Celica GT-S with a annoying
Replaced the MAF sensor - nothing. Took it to a authorized toyota shop & checked compression which check out good and put the computer on. Computer read mis-fire on cylinder 1, and then multiple misfire (like it would jump around). We went ahead and replaced the fuel injector on cylnder 1 - did not solve problem as when we hook the computer up, misfire seemed tp stay at idle and seem better when running high RMP, but check engine light is on as it never went away. Went ahead and replaced the coil pack to cylinder 1 - nothing. what am i missing?
Holes in the trunk?
These plugs are for draining water from the wheel well. There may be a leak behind the lights leave one of the plugs out for a day or too and see how it goes
I have a celica 2003
If the system is the factory system, the following procedure is how to disable it:
Open the driver side door and enter the car
Insert the key into the ignition
Turn the key to the "on" position, and then back to the "Off" position 5 times in 1 second motions
on-off on-off on-off on-off on-off on try to start
"On" is where the warning lights illuminate on the instrument panel
Sun Roof mis operation
Try when closing, hold button for 5 seconds when already closed and attempt to open. If it opens all of the way. Keep button depressed and hold button when it gets all of the way open,hol for 5 additional second and repeat this open and closed. This will tell the body sunroof ecu Walt the travel limits are
Burning smell, very hot and all 5 lug nuts loose on same wheel
Your brake caliper and/or brake hose is hanging up not allowing fluid pressure to release. Most likely your brake rotor is already warped from excessive heat also. Replace caliper(loaded or unloaded) and hose ,bleed brake system and you're good to go.
Not finding what you are looking for?