Check out the fault codes do the repairs , remove the codes and test drive to make sure the codes do not reappear .
SOURCE: automatic transmission is stuck in 2nd gear (limp mode)
most newer vehicles have transmission control modules,that go to a default of 2nd or 3rd gear when they go bad! I had a 91 plymouth stuck in 3rd gear because of this module! could be your problem! when mine went out, it smelled like something electrical burned inside the the passenger cabin! I would check all the electrical connections on the transmission first good luck
SOURCE: limp mode?
It may have a "loss of prime" code that usually follows a service of the fluid and filter. After you're sure the fluid is full at operating temperature, disconnect the battery for a few minutes and reconnect to see if the code resets. I hope this helps.
SOURCE: tranny stuck in limp mode
sounds like to prndl switch may be malfunctioning.
gear selector switch, which tells the transmission which gear it is in.
SOURCE: my trans is stuck in second gear. Is that what
The town and country vans are know for transmission problems and it would not be stuck in 2nd gear if it was in limp mode. Limp mode typically controls the engine. I have seen people do a transmission flush/filter and add lucas to temporary fix the problem. There is also a good chance that the transmission has a solenoid problem preventing it from shifting into any other gears but second. Hope this helps!
SOURCE: trans stuck in limp mode i'm getting a p1751 code
P 1751 Shift Solenoid" A" performance. The solenoid is part of the transmission valve body and yes if this solenoid fails you will get limp mode.The only solution is a new solenoid may be even the wires to it or even the transmission module
48 views
Usually answered in minutes!
×