Clustr probly worn out..xchange at napa for a rebuild. Cud also b worn wire harness
Testimonial: "it was a 2 amp fuse located along the steering column under the dash , removed lower panel by paddles and found it"
Goodjob...harness cud hav highr resistenc causin fuseproblm
×
SOURCE: chevy steering wheel controls
You first have to disarm and remove the air bag (unscrews with bolts from behind the steering wheel) and then you will see the screws for the switches. Only the silverado awitches will work.
SOURCE: 2001 chevy silverado 2500 hd, 6.0, replaced fuel
If you are sure the fuel pump relay is working, check continuity from the pump to the relay socket. These wires love to corrode. When you turn your ignition on, the fuel pump will only run for a couple seconds before it shuts off via the automatic shutdown relay. Make sure you are checking power within this window. The PCM (powertrain control module) is what completes the ground in order for the relay to send power to the pump. If the PCM does not recieve a signal from several sensors (mainly the Crank Sensor) it will not turn on the pump. You may want to check these sensors, is the check engine light on? You can scan it to see if any sensors have thrown a code. Be sure all applicable fuses are ok, the PCM may have its own fuse, check that even if the fuel pump fuse is ok. Your Truck may also have an inertia switch for the fuel pump which shuts it off during an accident. Check that as well.
SOURCE: 2006 Chevrolet Silverado 2500HD tail lights stopped working
I am having the same problem on an 04 2500hd there isa 15 amp stop light fuse inside the cab on the side of the instrument panel and a 25 amp stop light fuse under hood. you could also have a break switch issue the switch is located up on the break pedal linkage you should have power on the white wire when you push the pedal in (check with a test light) in my case I have a broken wire along the frame rail in the harness it is a light blue wire,
SOURCE: 2006 chevy silverado 2500 4wd a/c fan will not
look under the dash on the passenger side and you will see the blower motor, unplug the electrical connector and inspect it take special notice of the third pin from the left. they seem to have a common problem in that it melts the feed wire to the blower motor, a replacement plug kit can be found at most autoparts stores.
SOURCE: can't control my air
Hello! The Blend Door Actuator is defective..Dorman part # 604121...Cost around $50...Located on the lower left side of the Hvac assembly...Behind and below the drivers side dash...See picture below...Guru...saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
53 views
Usually answered in minutes!
×