Cars & Trucks Logo

Related Topics:

Angela Jacks Posted on Oct 15, 2018

Where is the mode actuator located in a 2014 ford expedition XLT?

1 Answer

Anthony

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 12 Answers
  • Posted on Apr 08, 2019
Anthony
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jul 06, 2012
Answers
12
Questions
3
Helped
3060
Points
24

It is under the dash

5 Related Answers

Anonymous

  • 50 Answers
  • Posted on Mar 13, 2009

SOURCE: A/C and Heater Blend Door Actuator

location is on ac and heater box under dash.Good luck big jab to fix it.

Ad
airjoc

Rob Sinbad

  • 709 Answers
  • Posted on Oct 11, 2009

SOURCE: 1998 Ford Expedition XLT 4 wheel drive switch is frozen in 4H

solenoid switch that engages the 4WD more likely will need replacing. fairly cheap to fix replace.

Manuel Cepeda

  • 3 Answers
  • Posted on Jan 24, 2010

SOURCE: 2001 FORD EXPEDITION XLT 4.6L V8 BLOWING MILD WARM

You hot air comes from the water circulated through the heater core. It is like a miniture radiator with water flowing thru it constantly. So by opening the "Blend Door" you are permitting so much of this hot air to pass thru.

Seems like for some reason your heater core is plugged up. Just like a radiator can be. So water may be passing through your heater core but not passing through fully. Your heater core gets hot from water passing throught it from the engine. Then your doors open up, in proportion to how much air is permitted to pass over the heater core.

Suggest to remove the heater core and replace it. Seems the blend doors are working properly but again, if you have a non working heater core then no air can pass over the "Hot Core" for you to recieve hot air.

If you are not mechanically inclined, then go to a local parts store and you can buy a car manual, such as Chilton's or Hane's Car manuals, for your year and make to show you how to replace it. Then you can also have it for any other problems that may arise.

fordexpert

  • 5692 Answers
  • Posted on Jul 27, 2010

SOURCE: What tires can fit a 1999 ford expedition xlt

I believe it will fit. If you go to DiscountTires.com you can use their site for alternate tire sizes. Especially handy is the feature which shows you the Speedometer error for different size tires. The site will also show you recommended and popular substitute tire and wheel sizes.

The 1999 model had a 265/65/17 as an alternative. You may want to ask the Tire store you intend to use if they can reconfigure your Speedo to be accurate. Some of the Fords can be done electrically without changing Speedo gears.

I did something similar by going from a "60" series to a "65" series in the same width. On my Grand Marquis, I gained 5% mileage improvement, but have to watch Speedo until I get it reconfigured. I hope this helps to answer your questions.

Testimonial: "can u help me a bit more, & tell me the size of rims & tires that could fit. im on a site called wheelsnext.com & i dunno which tires will fit or rims"

badfrank619

  • 1 Answer
  • Posted on Aug 06, 2011

SOURCE: 2004 Ford Expedition XLT, front blend door actuator

No airflow (cold or hot) through main vent ducts. Can hear the blower working, can feel air coming from in and around the dash area. Seems lik something is blocking the majority of air from coming through the vent openings. They(vents) are open but no air.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Location and/or diagram of the output speed sensor on a 2014 Ford F150 XLT transmission.

The output speed sensor on a 2014 Ford F150 XLT is typically located on the transmission tailshaft or the rear of the transmission case. It is used to measure the rotational speed of the transmission output shaft and send a signal to the vehicle's powertrain control module (PCM) indicating the transmission gear ratio.
I would recommend checking the vehicle's service manual for a more specific location and a diagram of the sensor, as the location and installation may vary depending on the specific transmission model and options your Ford F150 XLT has.
The output speed sensor is typically a small, cylindrical sensor that is mounted to the transmission case. It is connected to the PCM via a harness and may be located near the transmission oil pan or near the output shaft.
If you're unsure of its location or have trouble finding it, a professional mechanic will be able to locate and diagnose any issues with the output speed sensor.
0helpful
2answers

Need underhood fuse diagram 2007 ford expedition el xlt

There is no such thing as an underhood wiring diagram. Wiring diagrams are grouped by SYSTEM, not location. So you'd have to get separate wiring diagrams for the charging, fuel injectors, sensors, lights, etc. Even then it's difficult to get the exact diagram. Read this post on what's involvled.

http://ricksfreeautorepairadvice.com/get-car-wiring-diagram/
0helpful
1answer

2014 Ford Expedition AC Blowing through the floor vents even when HVAC controls are set for dash only.

Look for a vacuum line off or something stopping vacuum-operated doors from being able to open and/or close doors in or under the dash, or near the floor.
0helpful
1answer

How to remove an actuator on 2001 ford f150 xlt

You need to google 2001 f150 blend door actuator replacement. It is slightly right of center above the plastic duct work for the floor area. All lower dashboard plastic is removed to get at it.
Then the ducting is removed.
http://www.autozone.com/repairguides/Ford-Pick-Ups-Expedition-Navigator-1997-2000/Heating-and-Air-Conditioning/Blend-Door-Actuator/_/P-0900c152801e55ed
0helpful
1answer

Where are the tail light fuses located on a 1998 ford expedition?

what fuse controls the right taillight in a 98 ford expedition xlt

0helpful
1answer

2000 Expedition: I have a 2000 expedition xlt limited ed,but i dont...

Have you checked under the driver steering column? Mine was located here on a white sticker.
1helpful
1answer

Rear heater has a tick when turned on!!!

this is a rear temp blend door or mode actuators. the actuator is a small electrical motor that moves the temp/ mode doors inside the heater case to control from hot air to cold air. the actuators are located behind the pass side rear 1/4 trim 1 on top and 1 on the side of the heater case. remove trim and replace
5helpful
3answers

2004 Ford Expedition XLT, front blend door actuator

Hope I was avle to help, glad you up and going.
Not finding what you are looking for?

844 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...