My transmission has been having some harsh shifting so i went to the mechanic and he did an engine diagnostic and told me i need a transmission shift solenoid. i am having trouble locating this for purchase is it called anything else?
There are a number of shift solenoids in a transmission so unless the mechanic was specific as to what ratio is involved , it will be a case of replacing the wrong one
A lot of the time ,harsh shifting is from dirty oil and or oil pressure problems
May be it would be best if you went to an auto transmission specialist shop for a fault code reading and a proper diagnosis
SOURCE: where is the shift solenoid located on a 2003 dodge neon sxt
the trans shift solenoid pack is bolted to the side of the trans closer to the radiator. it is rather large and there are three 10mm bolts holding it to the trans. it is under the input speed sensor and just under the spot where the cooler lines go into the trans.
SOURCE: I need to know where the TCM is & Shift Solenoid "C"on 04 Kia Rio
The TCM is stuffed up in the drivers side dash just left of the steering column on this disposable vehicle. There are 2 modules there. One is a pcm and the other is a tcm. The onewith the large single black plug is the TCM.
SOURCE: Location of Shift Solenoid in 1999 Ford Expedition Eddie Bauer?
They are round "cans" with wires attached. You should have SSA, SSB, SSC, Torque converter and Pressure Control solenoids. They control pressures and have no mechanical linkage.
SOURCE: need to know where the 2-3 shift solenoid is and how to replace
Its in the pan, it will have a RED and YELLOW wire to it. I believe its on the side of the trans. under the side pan,
SOURCE: trouble with the transmission solenoid
USUALLY A SHIFT SOLENOID DTC IS REPAIRED BY REPLACING THE TRANS SOLENOID PACK ASSEMBLY..LOCATED ON OUTSIDE OF TRANSMISSION..YOU MUST BE CAREFUL WHEN CHANGING PACK..CLEAN ALL DIRT/DEBRIS FROM OUTSIDE OF PACK..YOU DON'T WANT ANY DIRT TO ENTER TRANSMISSION..SOLENOID IS A SMALL BOX LOCATED ON SIDE OF TRANS FACING FRONT OF VEHICLE..YOU MUST REMOVE TRANS COOLER LINE HOSES FROM FITTINGS ON TRANS..REMOVE INPUT SPEED SENSOR..UNPLUG PACK..8MM SCREW HOLDS IT..3 BOLTS HOLD PACK TO TRANS..YOU MUST CLEAN ALL GASKET RESIDUE THOROUGHLY BEFORE INSTALLING PACK..I'D RECOMMEND GETTING SOMEONE WHO HAS DONE THIS BEFORE IF YOU ARE NOT COMFORTABLE DOING THIS..I HOPE THIS HELPS
236 views
Usually answered in minutes!
×