Installing a Dual XDVD276 radio in a 2005 Chevy Impala without the factory end of the wiring harness.

Jeremiah Meyer

• 204 Answers
• Posted on Nov 21, 2008

SOURCE: installing after market stereo

Dave,

You will need to go buy a wiring harness adapter from your local Walmart (usually cheapest there) or Local Electronics place (ie Best Buy). The wire harness that goes out from the radio goes into the Adapter and the adapter plugs into the car harnesses. Also these Adapters come with the wiring diagrams for your vehicle. They typically run 10 - 15 bucks depending on where you get them. Thanks for using FixYa!

Sincerely,

JC

SOURCE: Radio Aux feature and not plug connection

http://www.installer.com/cars/by_car.php?carid=6330

SOURCE: So when installing an after market radio in a 2000

rest assured you wont have to change the deck every year to pass a emissions test.

SOURCE: how can i install an amplifier in my honda accord

By using an amplifier with "HI INPUT" jack. You would use the signal from the actual car speaker wires. just tap into them and extend it to the amp input signal. I would recommend a SONY amp that's cheap and reliable. You can get one 800-100watts from ebay or walmart for about 100 dollars. Get a amp wiring kit and you are good to go. Contact if you need more help. Thanks for using FIX YA.

SOURCE: I am trying to remove the center console of a 2003

There are 2 10mm bolts in the compartment hold of the center console that must be removed. Two similar 10 mm bolts must be removed at the front of the center console, near the driver's and passenger's lower legs. The top of the center console, where the shifter is located, snaps out. With this top piece removed, the cigarette and auxilary outlet can be disconnected. Four more bolts near the shifter bracket need to be removed, and then the console is free. Hope this helps someone. I needed to remove the center console to install a component for a car stereo.

Brian