SOURCE: Car will not unlock.
To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.
SOURCE: trunk release for 2000 mercedes s 430 not working properly
Trunk can be lock separate from the doors valet try unlocking the trunk with the key lock it with the door.Read the owner manual it will tell you about valet parking.
SOURCE: Noisy central locking Nissan MIcra
Hi there, this is a very common fault, you need to replace the drivers door actuator to stop the noise, ive done loads of these. hope this helps.
SOURCE: Key fob won't unlock or lock car VW Golf 2000
my mum had a similar problem and it turn out the code the key transmits to the engine had gone wrong she took it to a vw dealer and they reprogrammed the key. it works fine now and is a common problem. hope that helps
SOURCE: The trunk release (both on the door and on the key
If the fuse is okay, check to see that the latch is not bound in some way, and that it is properly lubricated. A dry latch sometimes will not release.
73 views
Usually answered in minutes!
×