SOURCE: location of spark plugs in 2005 dodge dakota
To change the sparks on a 2005 4.7L Dodge Dakota you will need the following:
Note you will have to remove the air intake located at the top of the engine, and will have to move some of the coolant lines out of the way.
At the top of the engine there are 4 sparks on each side. The coils are held in place with a 10mm bolt. Undo the 10mm bolt and unclip the coil. Next pull out the coil.
Insert the socket, with extension into the spark plug hole.
Remove spark plug.
Check the gap on new spark plug, it should match stock.
tighten to approximately 25ft.lbs. (check spark-plug packaging for exact torque requirements).
repeat this process with all other sparks.
be sure that no dirt gets into the spark plug holes.
SOURCE: location of the thermostat on a 2000 dodge dakota 3.9l v6 located
right in front on top of motor follow your top rattior hose to the motor
SOURCE: Where is the asd relay on my 1990 dakota?
ASD is in the engine compartment fuse block.
The pump relay should be there also. Check your fuse panel in the truck though.
Fuses, Relays & Circuit Breakers
The fuse panel box is to the right of the glove box with the glove box door opened or beneath the instrument panel (dashboard) on 1989-93 models.
Pull out the fuse panel for access to the blade type fuses
SOURCE: Manual transmission oil change method - Dakota
Disconnect the plug underneath to drain fluid, look in your service manual to find the capacity and viscosity. There is a plug in the side of the transmission as well that is the filler plug, however it is more convenient to pour through the shifter once you remove it. If you use the filler plug method you will have to attach a tube to the oil bottle and squeeze it into the transmission as there may not be ample room to tilt the bottle and use gravity.
[email protected]
Testimonial: "Thank you for this tip. The manual does not show capacity for the transmission but I found on other forums that the amount seems to be 4.8 liters."
SOURCE: where is the crankshaft sensor located on the
On the V6 and V8 engines, the crankshaft position sensor is bolted to the cylinder block near the rear of the right cylinder head.
Testimonial: "great thanks to info i found it now that i had right area just took a little coaxing got it out and replaced it thanks again"
780 views
Usually answered in minutes!
×