2002 hyundai sonata gls wont shift until 4000 rpm

SOURCE: How to install a alternator for a 2001 Hyundai Sonata V-6 GLS

Try “autozone.com” or your local library for diagrams and step by step instructions.

ZJ Limited

• 17989 Answers
• Posted on Jun 25, 2010

SOURCE: How do I replace the alternator in a 2002 hyundai

For 2002 Hyundai Sonata 2.7L MFI DOHC 6cyl check this procedure...
Alternator - Removal

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Remove or disconnect the following:
   Negative battery cable Radiator mounting bolts, 1.6L only Alternator drive belt Alternator wiring harness connectors Alternator. It may be necessary to raise the radiator
   
   
   Fig. Exploded view of the alternator-XG 300
   

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove or disconnect the following:
   Negative battery cable Alternator drive belt Alternator wiring harness connectors Alternator. It may be necessary to raise the radiator

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove or disconnect the following:
   Negative battery cable Radiator mounting bolts, 1.6L only Alternator drive belt Alternator wiring harness connectors Alternator. It may be necessary to raise the radiator
   
3. Install or connect the following:
   Alternator and reposition the radiator, if raised Alternator wiring harness connectors Alternator drive belt
4. Adjust the alternator belt and torque the bolts to the following specifications:
   1. Accent: Pivot bolt to 14-18 ft. lbs. (19-25 Nm) and adjustment bolt to 14-20 ft. lbs. (19-28 Nm).
   2. 2.0L and 2.5L Sonata, Elantra and Tiburon: Pivot bolt to 14-18 ft. lbs. (19-25 Nm) and adjustment bolt to 105-132 inch lbs. (12-15 Nm).
   3. 2.4L Sonata: Pivot bolt to 26-41 ft. lbs. (34-54 Nm) and the adjustment bolt to 14-18 ft. lbs. (19-25 Nm).
   4. 3.0L Sonata and XG 300: Pivot bolt to 14-18 ft. lbs. (19-25 Nm) and adjustment bolt to 11-16 ft. lbs. (15-22 Nm).
5. Install the radiator mounting bolts, if removed.
6. Connect the negative battery cable.

Colin Stickland

• 22516 Answers
• Posted on Jan 05, 2011

SOURCE: How do I replace front

the strut has two bolts at the bottom and one on top shouldnr take more than 10mins to dismantle ,unless you mean the suspension and the wheel hub ,even that isnt difficult maybe 20 mins depending on the corrosion state of the bolts

Testimonial: "Very good information."

SOURCE: Does 2006 Hyundai Sonata GLS

It's a chain. Go to www.hmaservice.com, create an account (free!) - they'll email you a password which you can then use to login to their site and get service information, manuals, etc.

SOURCE: power steering is leaking 2002 Hyundai Sonata gls

Hey, I had that exact problem. While there's no gaurantee that your's is exactly the same, here's where I'd start looking. There are two exhaust manifolds, one in the foreward part of the engine and another on the rear of the engine. The one in the rear is harder to see and access but there is a power steering line that runs pretty close to it. Unfortunately there is a non-metal section (bend) fairly close to the manifold and over time the heat made the "rubber" brittle and it just cracked and leaked profusely. Clearly a design oversight, but not the most difficult fix. I took the old line out and matched it to a power steering line (actually for another application) I found (or should I say the salesman found). I cut it to length and reinstalled it. It's a pretty tight area to work in. Finally, I cut a piece of old garden hose 4 to 5 inches and split it lengthwise and put it over the new section to avoid the heat deterioration that caused the problem in the first place.