Unable to start after i disable the kill switch

Hi Diane

Toyota Camera? Camry?

Disabled by the dealership? Why would they do that?

Kill Switch? There is no kill switch.

Disconnect wire to get it to start? Wires are permanently connected and you would CONNECT to get it to start, IF they disconnected it to stop you stealing your own vehicle.

So many Questions! :>)

Contact the dealership and tell them to give you your vehicle back in good running order.

Kill switch ? There is no kill switch on you Chevy > Now what seams to be the problem ? No start , the engine doesn't turn over ?

Hide the car keys lol Take the HT lead off the coil to the distributor. It wont start with out that or wire in a "kill" switch and hide the switch somewhere. A kill switch , is to switch on or off the ignition switch feed wire to the distributor coil. Its an old fashioned "anti theft" trick but with modern cars most don't have coils anymore, its all electronic.

I don't believe it has a kill switch.

Hi Alejandro,

A kill switch is a simple switch that interrupts power to the ignition system. You can attempt to start by cranking the engine over, but power is prevented from getting to the ignition coil / spark plugs so the engine will never start.

A kill switch can be a stand alone anti-theft device or is often part of an anti-theft system - that is operated by the driver often from inside the car. They can be as simple as a small toggle switch that is hidden away or can be related to requiring that the driver's foot be on the brake and the left directional must be on (or other combination of a number of devices) in order to start.

The simplicity of the kill switch relies on either (1) the stealthiness of its location or (2) method of disabling the switch to allow the engine to start and run (as described above). Since most are operated from the driver's seat, feel / look around under the dashboard, seat, console, etc. for a switch or other non-factory or suspect device that can be manually operated. Operate the device and attempt to start the vehicle.

Good luck!

In the installation instructions it will describe which wire in the cars loom to reroute to alarm. Find out and rejoin this wire.
This is considering it is aftermarket alarm

Easy. snip and strip one wire in the ignition, install small switch between the ends. Hide switch for your access only. (under the steering wheel or something) Simply disable ignition when you get out of the car and the key won't be able to start it.

There probably isnt a kill switch, but these cars did tend to have antitheft problems that would/will disable your starter. Here is a link on that

http://vatspasslockpasskeysecurityhelp.yolasite.com/

I was told the Kill switch is the cause of my Ford F150 not starting. It sounds like it wants to turnover but there's no fuel going to my motor, fuel line is dry and they can't hear the fuel pump turning on.

yes, do some internet searching, I believe there is a control that you unplug inside the hatch on the left hand side, remove the inside plastic panel, undo the connection, wait 5 minutes then reconnect. This I have done once along time ago on a 94 model. Remember I am only here to help and wish this works for you. Good luck.