2004 Chevrolet Blazer Logo

Related Topics:

Door locks keep blowing fuses - 2004 Chevrolet Blazer

4 Related Answers

Rwojt

  • 1 Answer
  • Posted on Dec 02, 2008

SOURCE: Security Light always on, door lock fuse keeps blowing

This is most likely a problem with your Passlock anti-theft system which is known issue with these cars. Passlock is a "passive" anti-theft system, which means that it will disable your ability to start the car if it thinks there is a problem. The three components that can cause this are: 1) Ignition Switch, 2) Ignition Cylinder, 3) Body Control Module (computer). The dealer is the only one who can solve this problem (unless you can bypass it, but it is not that easy). Estimated repair from most dealers is $800 and up.

Ad

Anonymous

  • 106 Answers
  • Posted on Jan 19, 2009

SOURCE: keep blowing out auto door lock fuse

after you replace the fuse try closing the door and put the key in and turn it back and forth locking and unlocking it and see what happens when you use the power lock
ray

Anonymous

  • 152 Answers
  • Posted on Apr 07, 2010

SOURCE: my door lock and window lock keep blowing my fuses

It is blowing fuses for a reason. You probably have a wire shorted to ground somewhere. You should get a test light and start tracing wires in your door panel. It may be obvious once you remove the door panel. It could be a faulty window motor or lock motor as well, but I doubt it. Get yourself a haynes manual, it will have the wiring diagram.

Testimonial: "thanks alot.will post the results later."

raj somaiya

  • 5370 Answers
  • Posted on Aug 29, 2011

SOURCE: Auto door lock on drivers

The most common cause of a single door lock not to work, is a bad door lock actuator (also called a door lock solenoid). Another common problem or cause of door locks not working is simply a bad door lock switch. But as per your problem, power window/ lock switch needs to be replaced.If the door lock fuse blows when door lock switch is depressed, then its quite possible that door lock switch is shorting.Bypass the door lock switch and connect the door lock switch wires directly to each other and then see if the door lock fuse blows with car key in on position.If the fuse is not blowing, then connect passenger side switch to driver side switch and then operate and see if the fuse blows.If not, then driver side door switch is faulty and needs to be replaced.-------- ---------- This will help.Thanks.Helpmech.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2007 Pontiac Grand Prix. Why does my auto door locks keep blowing a fuse when shifting out of park?

You need a good auto-electrician. Something in the shifter is causing that fuse to blow. It must have some shared power. Your doors work fine. Take the control apart and check for chafing, and check all the way down to the transmission.

https://fuse-box.info/pontiac/pontiac-grand-prix-2004-2008-fuses-and-relays

..
0helpful
1answer

My 2000 Nissan Pathfinder keeps blowing #24 fuse

Does the fuse blow as soon as it's replaced, or does it blow when some certain operation is performed such as opening a door, turning on the radio, or adjusting the climate control?
0helpful
1answer

Jeep keeps blowing fuse

You have a dead short and yes it could be in one of the door lock switches, figure out which one is blowing the fuses and take it out, might just have a wire that came loose in the back and is causing it to short out when you hit the switch button.
0helpful
1answer

M38 fuse keep blowing

the parts are shorted, the FUSE stops the fire. and flames.
we fix this buy isolating the shorted part.
we do that with an ammeter. (there are other ways, ask)
i see the ammeter prove short then
i try each door manually , 1 by one form the local door switch lock
to see if one door blows the fuse when activated.
BINGO, so then unplug that door lock solenoid, still blow the fuse
(i use a fuse substitute device (sold in all good auto-stores) called a fuse, circuit breaker converter)
lock sol, removed, still blows?, yes? then harness shorts, (hard work)
if Sol, pulled cures over-current, its bad. a shorted soleniod.

there are other ways, ill just list them.
no ammeter?
no C-Breaker.?
  1. use a light bulb in place of fuse. (i use a head light in a box)
  2. a current limited power supply in place of fuse. (see over current)
  3. Pul all parts, 1 by one on this bad line and a box of fuses.
there are 4 ways.
I always use an amp clamp meter on the line
and the circuit breaker trick.
then pull parts. and conn. on the bad feed. (lots there are)

that's it, for shorts.
1helpful
1answer

Fuse 129 keeps blowing x5

The warning light may not have been reset, door lock actuator bad creating a short - blowing fuse, or bad switch.
0helpful
2answers
2helpful
1answer

Fuse to suburban cigarette lighter/power locks keeps blowing.

Unplug cigarette lighter, check circuit, unplug each door individualy at first, Don't forget the back doors, check circuit. Usualy the door wiring is damaged but there may be more then two cigarette lightes depending on the model.
0helpful
1answer

2002 Dodge Ram 1500 power door locks keep blowing fuse

by process of elimination!
one door at a time so disconnect 3 & keep changing the active one till you find which one isnt working
then test its circuits ok
Cheers rob.
0helpful
2answers

Keep blowing out auto door lock fuse

You have a short Somewhere. Check inside the Door where the Harness goes into the Doors. It is the Black Flex duct that looks like a Vacuum hose.
Not finding what you are looking for?

84 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...