2005 Dodge Caravan Logo
M
Moses A Leathers Posted on May 12, 2015

Running problem. car has no power ,,,like the cat. was plugged. replaced the cps, cam pos sensor,map sensor, and the throttle position sensor and coolant temp sensor. cat has been temp. removed.can anyone help with this?

1 Answer

A

Anonymous

More likely a fuel delivery problem and highly likely related to the use of ethanol-based fuel.
Replace your fuel filter, and verify sufficient pressure at the fuel rail. Replace the fuel pressure regulator and/or the fuel pump as indicated by pressure test. Verify that rust hasn't clogged the fuel pickup strainer in your gas tank, and (as a precaution) replace ALL FUEL with fresh (ethanol-free fuel, if possible).
If you have not performed a major tune-up on the vehicle (including plug wires and coil packs) within the past five years or 50,000 miles, do so.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

97 jeep grand Cherokee. Has new tps, map,cps,catalyticconvert both oxygensensors,idle air, Pcv orifice,cam pos sensor, air filter, spark plugs,wires,and cap. I've replaced cat twice, first one lasted 9...

How many miles are on the engine? Have the valve seals ever been replaced? What kind of oil are you using in your Jeep? Does it smoke when it runs? If so, what color is the smoke?
0helpful
1answer

92 jeep wrangler 4 cyl 5 speed skipping and bogging down idling rough replaced fuel pump/filter injector o rings fuel pressure regulator timing chain distributor plugs wires map sensor crank sensor idle...

Have you checked the cam sensor? Also does that vehicle have a "throttle position sensor"? Some cars use both MAP and MAF sensors, not sure about your particular vehicle but if it is one of those, cleaning the MAF wouldn't hurt. Good luck.
0helpful
1answer

How to troubleshoot bad EGR circuit on 1988 Ford Ranger Injected

Have you checked for vacuum leaks at all lines and going to the MAP sensor? It also has a TPS(throttle position sensor) and CPS(crankshaft position sensor),I think.
I'm thinking vacuum leak or TPS. don-ohio
1helpful
2answers

I have a jeep grand cherokee i have a code p1296. voltage missing at throttle position sensor.explanation engine running and the ecm detected map sensor voltage less than expected. probable cause open or...

I would change the TPS throttle position sensor and the Map/MAF are you sure its not the mass air flow?. I think your computer is fine it could be have a loose ground issues but computers dont go bad.
0helpful
1answer

My 1993 jeep 4.0 runs bad when it gets warmed up

It is either your throttle positioning sensor (most likely) or your pre-cat o-2 sensor. But most likely your throttle body which only costs like 50-60 dollars i think.
0helpful
1answer

1997 gmc jimmy

Sounds like the cpi injector assembly. The fuel pressure regulator may be leaking. Or the poppet valves on the injectors may be sticking or shot. I replaced almost every part on my truck and that is what it ended up being the whole time. It's a common problem on these models. Hope this helped
5helpful
2answers

I have a 2004 jeep wrangler and i am reading the codes p0122 p0123 and p0432 can anyone let me know what these dtc's mean and if possible how to fix what it broken

P0122 - Throttle Position (TP) Sensor Circuit Low Voltage
P0123 - Throttle Position (TP) Sensor Circuit High Voltage
without checking it 1st I would guess the TPS is most likely defective.
P0432 - Catalyst System Low Efficiency Bank 2, you may have to replace the Catalytic convertor, it may be worn out,
A WORD OF CAUTION: Don't use aftermarket cats, they tend to reset the same code due to compatibility issues, also replace the cat monitor sensor (looks like an O2 sensor) located just to the rear of the bank 2 cat converter.
0helpful
4answers

Totaly confused now 1995 Delta 88

I think you should use our live chat option, tech's are better at giving out detailed info if they are getting paid to do so.
0helpful
1answer

96 cavalier 2.4 starts runs great -chokes

Check the crankshaft position sensor. If the plug is loose or the sensor itself is bad it will cause similar problems
Not finding what you are looking for?

110 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...