SERVICE STAB SYS fault Message
The IPC displays the traction fault message when either of the following instances occur:
?€¢
The EBCM detects a malfunction that requires VSES to be disabled. The EBCM sends a serial data message to the IPC requesting that the message be displayed.
?€¢
The IPC detects a loss of serial data communication with the EBCM.
With out a factory scan tool your not going to be able to do anything with This . Save yourself some money an aggravation , take this to the dealer if you don't know what a serial data communication network is ! An I'm sure there are codes stored in the EBCM !
Wit
If the system fails to turn on or activate, the StabiliTrak®
light along with one of the following messages will be
displayed on the Driver Information Center (DIC):
TRACTION CONTROL OFF, SERVICE TRACTION
CONTROL, SERVICE STABILITRAK. If you see these
conditions, turn the vehicle off, wait 15 seconds, and then
turn it back on again to reset the system. If any of these
messages still appear on the Driver Information Center
(DIC), your vehicle should be taken in for service.
897 views
Usually answered in minutes!
×