20 Most Recent 2008 GMC Acadia Questions & Answers


Try spraying contact cleaner to your on/off sw., turn the sw. on & off 5 or 6 times, also try spraying the door button sw.

2008 GMC Acadia | Answered on May 30, 2019


It means the unit isn't reading your CDs/DVDs. It most likely means the unit is broken and needs to be replaced. There is no fix that I know of for CD/DVD units, only replacing.

2008 GMC Acadia | Answered on Feb 26, 2019


What alarm ? content theft alarm ? No fuse
When armed, the content theft deterrent (CTD) system is designed to deter vehicle content theft by pulsing the horns and exterior lamps for approximately 30 seconds when an unauthorized vehicle entry is detected. However, the CTD system does not affect engine starting.
An unauthorized entry can be any of the following with the CTD system armed:
• When any door is opened without first being unlocked using the keyless entry transmitter
• After a battery reconnect, if the battery was disconnected with the CTD system armed
The components of the CTD system are:
• Body Control Module (BCM)
• Security indicator
• Door ajar switches
• Liftgate ajar switch


Is this the alarm your talking about ?

2008 GMC Acadia | Answered on Sep 14, 2018


The radio and BCM needs read for codes. No reason for the radio not to work after a FOB program. Just a guess, but if the battery power was to low, radio is locked out.

2008 GMC Acadia | Answered on Apr 09, 2018


You have so many questions...First i would pick up a wotkshop manual .

2008 GMC Acadia | Answered on Feb 03, 2018


Very poorly designed. You can try pulling inner fender wet off and see if you can access bulb. I have done this on arcadia which is same car. There are plastic plugs and screws, remove enough to get your hand in there.

2008 GMC Acadia | Answered on Nov 12, 2017


What garage was it at ? Dealer reduced engine power means there is a problem with the electronic throttle control .this will shut off traction control off . Were there any DTC'S - diagnostic trouble codes read from the PCM - engine computer .
No crank REDUCED ENGINE POWER case study 13 GMC Acadia Part 1

Drive by Wire Function and diagnostics by Wells

2008 GMC Acadia | Answered on Sep 16, 2017


Hey Jd.. How lang has it been since the dealer "repaired" it??..is it still in their warranty??..
try this number for help..have your records available...

Be PERSISTENT!!

CONTACT US

GMC Owner Assistance

2008 GMC Acadia | Answered on Aug 01, 2017


{: ) Your stabilitrak system may not work properly. The vehicle need to be scanned for trouble codes. In case you get a C0196 code, the recommendation is to reprogram the electronic brake control module. I hope that's the only cause.

2008 GMC Acadia | Answered on May 08, 2017


The problem might be that the alternator is faulty or the idle screw is making the engine run at a very low speed when idle.

2008 GMC Acadia | Answered on Apr 20, 2017


There is probably a small drain on the battery - perhaps the luggage compartment light isn't switching off.

The car alternator isn't really capable of recharging a battery due to it's high internal impedance. It is better to recharge it independently.

2008 GMC Acadia | Answered on Mar 23, 2017


I had the same problem. I started by applying penetrating oil to the bolt and then I tried a 2 jaw puller. But the jaws would not fit between the arm and the windshield. I then used a 2 1/2 inch "c" clamp and it fit perfectly. Turned the clamp bolt a few times, and the arm popped off the stud in about 10 seconds.

2008 GMC Acadia | Answered on Dec 08, 2016


I haven't found a bad motor yet. It has always been the magnetic lock. Its part of the regulator. It is because of the coil burns or the gears strip out(plastic) . The regulator is on the drivers side, of course at the rear of the vehicle. You have to remove the bezel at the top, the is a square on it(pop it off) that has a bolt/screw to remove. The bottom bezel needs popped off to a point. It does need to be removed, but pushed up to a point that you can get to the regulator. If you want to remove it, the rear seat has to come out. Remove the bolts holding the regulator. unplug the electrical connectors.. Just a note. I do electrical/electronics on cars. I do have to pull panels sometimes to get to motors like these to check. I use a scanner to check every aspect of the/any system.. It could be a bad switch in the dash.

2008 GMC Acadia | Answered on Nov 12, 2016


Fixya does not sell flashers.

2008 GMC Acadia | Answered on Oct 30, 2016

Not finding what you are looking for?
Cars & Trucks Logo

662 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2007 GMC Acadia SLE
2007 GMC Acadia SLE

217 Questions

2009 GMC Acadia
2009 GMC Acadia

163 Questions

2010 GMC Acadia
2010 GMC Acadia

37 Questions

2011 GMC Acadia
2011 GMC Acadia

48 Questions

2013 GMC Acadia
2013 GMC Acadia

10 Questions

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Acadia GMC

  • Acadia GMC

Most Popular Question

2008 gmc acadia rear c heat relay or

  • Cars & Trucks
Loading...