How do I go about installing a Warn winch on the metal bumper and chassis of a 1996 3.0l v6 Mitsubishi Pajero without modifications? Cables are standard Warn designed for this winch.

Contact where you bought it from. It is a winch without a maker which these days, means it is made in China and there is no Support!

https://www.google.com/search?q=Arvada+winch

.

see if this link helps you out.
94 v6 mitsubishi pajero turns over will not start Google Search

Try to tap it with a soft hammer while pressing the start.

I don't care what vehicle you are fitting it on I must emphasize make sure you use high ampage cable with very good earth, most important use at least 10mm cable
John

if you can use the winch manually by pressing buttons on the winch then the problem will be in either the remote unit(Battery in back to front) or the receiver in the winch

Hi there, firts of all, if your car its not designed to have that sensors and you draw over the bumper, past the metal plate and after the plate, you maybe find that the holes are not an acces point to get inside the car. That part conforms the collission metals and i guess you have some warranty that maybe that modification cant disable it. I remember that the metal plate in other cars have some holes from design, maybe you could remove the bumper, locate that squares and put your sensors there, but has i said, its not a point to get inside the car for the cables.
Hope this help you.

This question was listed under the 1990 Mitsubishi Minivan.

For the 1992 Mitsubishi Pajero V6 3.0L:

Firing Order:
1-2-3-4-5-6

Cylinders:
.....(back)
5..............6
3..............4
1..............2
.....(front)

Distributor:
....(back)
............(+)-screw
......2
1.........3
6.........4
......5
(+)-screw
....(front)

Let me know if this helped, or if you have additional information opr questions. Feel Free to contact me at FixYa.com!

Engine what????

Oil = 4.5 Litres or 1 Imperial gallon

It should be on the cyllinder block just below the head