Where is it located in this vehicle
SOURCE: malibu air bag module location
The module is under the passenger side seat,under the carpet.You will have to remove the seat to access it easier.Lift up the carpet and it will be mounted to the floor.
SOURCE: 2000 Chevrolet Malibu LS airbag problems
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
SOURCE: location of module
The Sensing diagnostic module is under the passenger seat under the carpet
SOURCE: Air Bag Module
you need to takee into a certified mechanic , if you mess with the air bag system and it deploys no one will work on it . the cost to replace your airbag system could be easily 2500.00
130 views
Usually answered in minutes!
×