SOURCE: 2002 Hyundai Accent Problem
first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
later paul
SOURCE: 2000 Hyundai Accent will suddenly stall and wont restart
Have someone check the idle sensor. I had to have mine replaced along with another that I don't remember which one is was.
SOURCE: hyundai accent stops running after heats up
I had the exact smae problem and threw aaway a ton of money on bad "guesses" at what was wrong. The actual fix was replacing the crank shaft position sensor for 50 or 60 bucks. Swapped out bad for good and cars has run great every day since.
SOURCE: Just had oil changed, dipstick reads full, but oil light flickers
the light is probably sending an OIL Pressure drop warning ---there is a rarity however
an oil filter may be improperly installed or the OIL Pressure connection on the oil pressure
sending unit --usually next to the filter --is loose or corroded or the oil pressure sending unit may
be going bad ---on a 2001 it is conceivable
otherwise you have an internal oil pressure leak --crank or cam bearings --bad o ringy thingy somewhere or the oil pump --may be experiencing problem too or the pick up screen in the oil pan
is somwhat clogged ---for a clog --try what's called SEAFOAM in the oil ---the stuff actually works
like it says on the can --about 8 bucks --drive for a week --say 500 miles worth and change the oil filter again --just the filter ---either way OIL Pressure is nothing to ignore ---you need to fix that
asap depending on the problem source!!!
I hope this helps
HAWK
SOURCE: 2000 hyundai accent code 302 misfire and slow responce o2 senser
Yep!.. Typical with an engine cylinder misfire. Inspect the plug and ignition wire, especially the insulator. If you see a 'christmas tree' pattern on the insulator, that's where your problem is.
101 views
Usually answered in minutes!
×