20 Most Recent 2011 Hyundai Accent Questions & Answers

Tidied up the question a bit. Question moved to sub category Did the inability to start happen right after you put the new battery on? Did you reset the security system?

P0343 HYUNDAI Code Camshaft Position Sensor 'A' Circuit ...

https://www.autocodes.com > p0343_hyundai Repair Information for P0343 Hyundai code. Learn what Camshaft Position Sensor 'A' Circuit Range/Performance means, location and how to repair? Dirty connections and grounds!

P0626 OBD-II Trouble Code: Generator Field/F Terminal ...

https://www.yourmechanic.com > Articles P0626 means there's a fault on the generator field circuit due to a faulty alternator, battery, wiring, or poor communication between control module.

P0342 HYUNDAI Code Camshaft Position Sensor 'A' Circuit ...

https://www.autocodes.com > p0342_hyundai Repair Information for P0342 Hyundai code. Learn what Camshaft Position Sensor 'A' Circuit Low Input Bank 1 Or Single Sensor means, location and how to ...

run the fault codes but a fried ECM and alternator are distinct possibilities

EVAP Emission System Pressure Sensor http://www.autocodes.com/p0450_hyundai.html

Same as any other engine. The head gasket can blow between two cylinders, in which case compression in each will be very low, or it can blow/leak water into oil such that the oil will be milky looking, or it can blow to the outside and show as leaks. One good way to test individual cylinders, is to remove a spark plug and screw in an air chuck made for this use and hook up compressed air. Is you then see bubbles in the radiator coolant gasket is leaking, or if the dipstick blows out the leak is to the oil.

I would have the OBD codes read as should give code of the faulty sensor,switch etc, you say this is what happens when you clean it , did you get the engine bay steam cleaned ? If so try spraying a water disperseant over all the electrical connectors , WD 40 is a good product for this , good luck

Most dealers repair operations are not to be trusted. They make the brunt of their money on repairs and parts and will do and say just about anything to increase business. Get a few more more diagnosis from other repair outfits and then decide.

have you tried to turn the steering wheel and then turn the key? when the steering wheel is locked it will not let the key turn, try turning the steering wheel to the right and then turning the key. Sometimes when getting out of the car your leg turns the steering wheel and locks it.

Multifunction switch .

Lots of reasons. Do a diagnostic test to find what codes come up. That way you won't waste a lot of time looking for the problem.

PROBABLE REASONS ARE;- - Mode control not working - Climate Control resistor bad - Blower motor weak. - Something stuck in the Air Duct. I’m happy to assist further over the phone at https://www.6ya.com/expert/uttamjeet_2f3adc18600f8ede

Either slave cylinder or master has leaked fluid, you may be able to fill system to get by for a while

Linda look like there a plastic bag that on your cathalitic converter get the car on a lift and get it scrap it off if not its gonna smell for weeks

when was last time you had tune up? spark plugs etc

I would think not but if it is a manufacture suggested maintenance item, I would do it.

This sounds like a battery or battery cable concern due to corrosion, bad battery or bad/ poor connection.