What is the question, above is facts.
but now questions.?>??????
eg:
wild guess, id need to drive it first.
but BAD BRAKES.
c2116
lets google that for free, here i type for you
10k hits, 1st is below.
http://www.jkowners.com/forum/showthread.php?t=47724
is this clear, if not get it service,
low battery voltage
fuse blown?
are 1st steps if DIY.
SOURCE: my esp and bas light will not go off on my 2007
The ESP/BAS system is a separate system from the engine computer/check engine
light system, if your steering wheel is off center just a 1/2 degree, the light will set. Most scanners will not detect a code. It takes the Jeep protocol to reset it.
I hope this helps.
SOURCE: i have a 2006 jeep liberty and three lights are staying lit and
You need to take the jeep to a dealer or a good mechanic who can retreive the codes out of the computer. You may have a module problem but I will not guess without knowing the codes.
SOURCE: I have a 2007 Jeep Compass Limited 4x4 and the
The lights are being turned on by your BCM or Body Control Module. It's located under the driver's side knee bolster, but it will probably have to be taken to the Dealership to hook up their DRB III to ascertain as to why the BCM is turning on all of your lights.
"00 Buck"
SOURCE: ESP/BAS
If the ESP light is on, the system is not functioning. have your dealer look at and replace your Brake Light Switch
7,911 views
Usually answered in minutes!
×