How do I reset the brake light code

I believe the fluid/brake light is only intended to indicate the parking brake is on or the master cylinder reservoir is low . ?????

Wrong !!!!!! problem's with ABS can also turn on that light as well ! Take it a have codes checked .

These are all different circuits. The brake lights are on a 10amp fuse - the headlights are on a 50amp fuse - and the parking and dash lights are on a 20amp fuse.
Do you have power going into the headlight switch and the brake light switch ?

first check to see if you have enough brake fluid in the resevor and that you don't have a leak somewhere. If not you might be able to have a code reader pull the brake codes. If anti lock brakes it might be as simple as changing a sensor. If everything is checking out disconnect the positive battery cable for 10 minutes, this should clear the brake light. As for the chiming you will have to dig around under the dash to find the little noise maker and then unplug it. I just had to do it to my car and truck.

You can reset this fault code using the buttons on your dash - you don't need a dealer to do this. As you already know, you need to replace your pads and the brake wear sensor - this is a sacrifical item. Once this is done, do the following:-
Using the buttons on your dash - there are 2 - one on the LHS (Trip reset) and one on the RHS (In between Tacho and temp gauge)

*Press and hold Right button and turn ignition to first position (I or Accessory)Display should show "Check Control OK" then a short time later "Test Nr.01"*Press the Left button and you should see the car info in the display. Add the last FIVE digits of the car identity number together (NOT all 6!) to get a unique ID for your car.*Press the Right button repeatedly until you see "Test Nr.19"*Press and hold the Left button until you see the number matching the unique ID you calculated, then release.*Press the Right button to select this.*Press the Left button repeatedly until you see "Test Nr.21" - Reset All Defect Codes*Press Right button to reset the codes.Done!

Rear brake Change light was on at 600 miles to service .got brakes changed and tried to reset dash on rear brake but went to. -15000 then brake light came on instead how do I get the light off?

to clear the code disconnect the battery, you could have a bad brake lite swich, its under the dash by the brake pedal

it's a break pad sensor, your pads are worn out,if you wait to long, you"ll ware thru the sensor and have to replace it. it's not a hard fix, you"ll have to clear the code to remove the dash diagram, after u fix the brakes, and maybe the sensor, good luck

scan tool the brake light is a trouble code have it scanned some auto stores such as auto zone / advanced auto do it for free the code is a place to start they can also reset and clear the code

Check the brake light switch under the dash at the brake peddle and make sure its working if it does not close when you depress the brake peddle the lights will not work You may hve to remove the lower cover for the dash to get at the switch

you must check the layout first if the layout is ok then trace from the dash boards connection and you will know what wrong with the dash board lighting system,.after that contact your auto eletrician to re-connect the wires in the dash board.thank you