Spark plug gap and timing mark lineup for 2000 xterra 3.3l v6

The Dodge 4.7-liter engine requires a spark plug gap of 0.038 to 0.042 inches.
Google 2003 Dakota v6 hemi spark plug gap for more info

I really needs checking against the spark plugs you have chosen? .045" is about right for most.

1989-1996 Oldsmobile Cutlass Ciera 3.1L 3.3L V6 6 pc NGK ...

https://www.sixityauto.com > 6-pcs-ngk-v-power-spark...
This 6 pack NGK V-Power Spark Plug fits your 1996, 1995, 1994, 1993, 1992, ... 1989, Oldsmobile, Cutlass Ciera, 3.3L V6;Gap 0.060";Oe Equivalent Design ...

• 
  

  1987-1995 Oldsmobile Cutlass Ciera 2.8L 3.1L V6 6 pc Champion ...

  https://www.sixityauto.com > 6-pc-champion-copper-sp...
  6 pc Champion Copper Plus Spark Plugs for 1987-1995 Oldsmobile Cutlass Ciera 2.8L ... 1988, Oldsmobile, Cutlass Ciera, 2.8L V6;Plug Type Rs15Lyc; Gap 0.045"

What is the Spark plug gap on 95 olds cutlass Cierra? - Answers

https://www.answers.com > What_is_the_Spark_plug_g...
Aug. 4, 2007 - Standard gap is .060" or 1/16".Ask at auto parts counter when purchasing spark plugs. What is the 1972 olds cutlass 2 barrel spark plug gap ...

It is probably in the owner's manual under "Specs"
RockAuto shows it as .060 on the 3.8.

2000 CHEVROLET IMPALA 3 8L V6 Spark Plug RockAuto

just put them in 1mm

no engine stated? wow. 3.5L? says no gap settings.
its in the FSM. many cars dont put it in the op guide as the plugs
are rated to 80k miles or more, and is not consider, operator deal.
sadly.
and many folks think the new plugs are set in the factory , WRONG. (comment is for J plugs not surface fire tech)

i see you are there.!
many stores, list it wrongly too.... vast....
but you never said country car was sold.
in the USA we open the hood, look up and behold, its right there.
the vacuum and turn up sticker,
now alldata.com
quotes to follow.........all.
the original equipment spark plugs installed in the Odyssey 3.5L V-6 engine are platinum tip spark plugs, and the plug gap must not be adjusted.
and other warnings, and the no file them warn.g
On CR-V and 4-cylinder Odyssey models, adjust the spark plug gap to 0.039-0.043 inches (1.0-1.1mm). On Odysseys with the V6 engine, check, but do not adjust the spark plug gap. The spark plug gap should be 0.039-0.043 inches (1.0-1.1mm). If the spark plug gap exceeds 0.051inches (1.3mm), replace the spark plug.

so 1mm , if not v6

Sounds like carbon fouling. Easy fix is run an aggressive fuel injector cleaner as recommended by your local parts store through the gas tank. Also ensure that spark plug wire is firmly attached. If you took the plug out-you know it is a pain to get to it! A easy way to see is to start motor and idle, pull #6 wire off at distributor when it should be attached to plug and see if the idle changes. If it doesn't, the wire is not plugged on the spark plug or the rotor/distributor may be faulty.

Another more difficult task may be the removal and replacement of the fuel injectors them selves (or cleaning by a specialty shop). Good Luck!

Make: FORD
Model: EXPLORER
Year: 2000
Engine: V6 - 4.0L - FI - - GAS

Part Number RS12YC
GAP .054" (Original Equipment Manufacturer and/or Original Equipment Equivalent)

Good luck.

It depends on which engine you have fitted.

If it is the V6 3.3 ltr engine the plug gap is .039 inches

If it is the 2.4 liter engine the gap is .044 inches.

S

Pull # 1 spark plug, install compression gauge or somehow block hole and jog engine until you feel or record compression, then line up TDC marks on crank pulley. Now when you drop distributor in, rotor should line up with # 1 spark plug wire tab under cap. Make sure you have all ignition spark disconnected, one way or another. If you haven't pulled other distributor yet, it should be easier, just mark housing for reference, jog until rotor is at # 1 tab, remove old one and re-install new in same position.