Hyundai tucson crdi fitted a new throttle pedal but p2113 fault code keeps comming back

these are what your codes are https://www.obd-codes.com/p0401 https://www.obd-codes.com/p0441 P2125 Throttle Pedal Position Sensor Switch Circuit P1193 Electronic Throttle System Limp Home Low RPM

Please just google this, GM fault codes P2138, P2123

What is the DTC code that you are getting ?

uh oh, 1186 and 0087 are both related... fuel pump or the filter or both! either case the filter is now located inside the fuel tank

P1186 Hyundai Fuel Pressure Too Low


P0087 Fuel Rail System Pressure Too Low

"Potential causes of a P0087 trouble code may include: Weak fuel pump, clogged filter or screen, restricted fuel supply line Faulty fuel pump driver module Faulty fuel pressure sensor"


How to Change the Fuel Filter on Hyundai Tucson eHow

according to eHow, you can access the filter relatively easily. (although the pic is an illustration of something not really related to this ~ why they showing a fuel petcock that's not even on your car?)

P2112 Throttle Actuator Control System Stuck Closed

"Possible causes:
- Throttle Body Plate Binding
- Faulty Throttle Actuator
- Throttle Actuator harness is open or shorted
- Throttle Actuator circuit poor electrical connection"

older models we had the gas pedal attached to a cable to move the butterfly valve on the throttle body. Now it's this newer drive-by-wire stuff... remove air intake hose and check / clean / move the throttle body valve by hand first to see if it's binding or not

then, go from there on testing the actuator and tps

Here is what the code is. I believe it is also called a TPS (throttle position sensor). On most carburetors it is on the side opposite the throttle linkage. You can take it off and test it with an ohm meter. All it is is a variable resister (like a volume knob on a radio) as it turns it changes resistance and that info is sent to the computer witch in turn tells the computer what position your throttle is.
On most cars it is an easy thing to change out and not very expensive. Good luck
P2113 Throttle/Pedal Pos SensorB Minimum Stop Perf

you need to have the throttle position sensor adjusted by the dealer using a tec 2 scanner.

On many diesels, when I read codes they mention an egr valve, but what they are really talking about is the throttle actuator. What I don't understand is why you no longer have any codes. there are some codes which do not turn on the light on the dash because the computer hasn't decided yet that it is a hard code, so check for them anyway. The symptoms you are describing usually turn out to be either the throttle actuator, fuel rail pressure regulator, or a ripped turbo hose

check your clutch pedal for free play it should be 3/4" it might be adjusted up to much, you might have to adjust it off a little....hope this helps....cheers

My brand new 2009 Tucson has the same problem. My dealer said it needs a 3rd Gear Kit fitted.
They are on back order as a number of other Tucson's have the same problem. I may have to wait 3 months for the part.
My dealer has ordered 126 back order parts for this problem.

dear friend-your vehicle need to be hooked up to a HI-SCAN-PRO or GDS in order to read your fault codes.only if you have a fault code will you be able to carry out any repairs.