Vsc code c1336 - 2006 Toyota RAV4

When a warning light is on, a trouble code is stored in the computer. Get the code read to find out what's going on. Hard to guess without knowing the code.

Hi
If you go on the net and google the code theres loads of info on the Lexus forums about that particular error code it sounds like an easy fix
Hope this helps Nick

what were the code numbers you gave me code c1336 This means there is a zero point calibration code unfone. So you need a zero point calibration needs to be reset with a scan tool.

http://www.toyota-4runner.org/5th-gen-t4rs/71093-yaw-rate-acceleration-sensor-zero-point-calibration.html

You might have a bad deceleration sensor or possibly a bad connection between the sensor and the module.

go get your codes read. sounds like possible misfire due to lack of power. call around alot of places read codes for free then you can start there.

Tests/Procedures: 1. Perform zero point calibration of the yaw rate sensor/deceleration sensor. Potential Causes: Deceleration Sensor Zero Point Calibration
Tech Tips: Code C1336 is for Deceleration sensor zero point calibration undone. To perform zero point calibration, have the steering wheel in the straight ahead position and have the vehicle on a level surface within an inclination of 1%. Turn the ignition switch OFF. Use a jumper wire and connect terminals TS and CG of Data Link Connector (DLC) 3. Turn the ignition switch ON. Keep the vehicle stationary on a level surface for 2 seconds or more and verify that the VSC warning light blinks. Diagnostic Codes: C1336

The VSC light.VSC stands for "Vehicle Stability Control". disconnect the negative battery terminal for few minutes then reconnect it again then check out if the VSC light is still coming On. ------------ But if this does not help you to solve the problem then this "VSC light On" problem is related to loose vacuum hose.Properly check the air filter the vacuum hose thats behind the air box ,if this vacuum hose is loose then you will get the VSC light. -------------- Also check the gas cap,if the gas cap gets loose then this can cause the problem. ----------- but if all this possibilities checked ok and still the VSc light stays on,then this problem has to be checked by retrieving codes at diagnosis center.You can get your car scanned at www.autozone.com.Its absolutely free to get car scanned at auto zone service center.Once the error codes are retrieved the exact faulty part can be replaced as per the codes. ---------------] Keep updated for any more queries.Thanks.

could be alot differnet things u need to take it some where to have codes scaned on it more than likely it a bad speed sensor but cant tell for sure until codes are scaned

My 2000 Lexus GS 400 just had the VSC/VSC off light and the check engine light come on. I would have to push the accelarator peddle all the way down to get it to go. Took it to the Toyota dealer and the code pulled up as the Throttle Position Sensor was out. Purchased one and having it put in. Will update if this fixes the problem.